REDUCTION OF COST AND TIME CONSUMPTION IN WELL-CONSTRUCTION
Journal Title: UNKNOWN - Year 1998, Vol 10, Issue 1
Abstract
A Contractor usually utilizes the available drilling equipment when constructing just one single well. Drilling cost and time consumption in constructing the well MB-1, using the percussion method, and the well MB-2, using the conventional rotary drilling method, call for a separate analysis in order to justify the investment cost for the acquisition of additional equipment for a single well only. The wells, located in a karst vrtača close to an estavelle near Tomislavgrad, with a diameter of 500 mm and approximately 80 m deep, have been accomplished with a low rate of penetration using the conventional Cable tool and resp. Rotary Drilling Method. In this paper results of analyses for the given circumstances are shown: both the efficiency and cost of the mentioned drilling methods performed by the crews of »Geotehnika d.d.« Zagreb, as well as the justifiability of investments in new equipment are evaluated.
Authors and Affiliations
Mladen Zelenika Božo Soldo
Keywords
Related Articles
- EP ID EP29888
- DOI -
- Views 162
- Downloads 4
STRUCTURAL AND STRATIGRAPHICAL RELATIONSHIP IN THE ESTERN PART OF THE DRAVA DEPRESSION - WIDER AREA OF THE FIELD BENIČANCI
This article closely defines the stratigraphic-structural relations within the eastern part of the Drava depression. These relationships are explained in detail for more important fields of the investigation area such as...
SLIM-TUBE SIMULATION MODEL FOR CO2 INJECTION EOR
A simulation model of the slim-tube test has been developed to validate the laboratory experiment and used EOS as well as to investigate the possibility of serving as a fast and reliable tool for MMP determination. Sensi...
UPOTREBA RAČUNALA U OPLEMENJIVANJU MINERALNIH SIROVINA
U oplemenjivanju mineralnih sirovina računalo najčešće koristimo za potrebe simulacije postojećih odnosno projektiranje novih uređaja i procesa. Za to je neophodno poznavanje teorije procesa i odgovarajućih modela koji o...
INOVATIVNI MODEL ZA ISTRAŽIVANJE I OPISIVANJE OBRAĐENIH TALOŽNIH STIJENA ANALIZOM ZVUČNIH (AKUSTIČNIH) FREKVENCIJA DOBIVENIH TIJEKOM BUŠENJA
Određivanje geomehaničkih svojstava stijena ima važnu ulogu u njihovim opisima i karakterizacijama u svim geoznanostima. Samo bušenje takvih stijena gotovo je obvezatna operacija koja se izvodi tijekom njihova ispitivanj...
POSSIBILITIES FOR GROUNDWATER POLLUTION OF THE STIP AQUIFER REGARDING ITS HYDROGEOLOGICAL CHARACTERISTICS
The paper presents research on filtration characteristics of the alluvial sediments of the Stip aquifer in order to determine the degree of protection from ground water pollution. Previous studies determined that alluvi...