REDUCTION OF WAVE AND ROUGHNESS OF THE EDGE PREPARATIONS FROM THE ACTIVITY OF THE SPEED JET IN HYDROREASIS SYSTEMS WITH MOBILE PREPARATION
Journal Title: Вісник Кременчуцького національного університету імені Михайла Остроградського - Year 2018, Vol 1, Issue 111
Abstract
Purpose. To determine the growth performance and to evaluate the possibility of control of the tension state of the zone water-jet cutting means pre-loading the blanks. Methodology. The computer simulation of the loading of the slab with the definition of areas of strain, with various influences (tensile force, torque and combined effect of force and torque) was conducted. Results. Hydro-cutting systems offered in the market of industrial equipment, as a rule, have a traditional layout, which provides a horizontal arrangement of the workpiece on the table, which is also a pool-trap for the flowing jet of liquid. However, when processing high-precision products that require stable quality of the ends, such systems are of little use, since periodic flow of the jet onto the table supports cause a change in the interaction conditions and lead to processing defects. It is proposed to use systems with a fixed jet head, and to make work movements due to the motion of the workpiece. However, in this case, wave phenomena in the jet are actively manifested, so a further increase in the accuracy of the contour and the quality of the end face is seen in the establishment of rational conditions for the interaction of the jet with the workpiece at variable rates of relative motion. Originality. In work the conditions of occurrence of oscillations are analyzed, regularities of formation of defects of an end are established which can be leveled by maintenance of variable speed of contour submission with corresponding damping of links of system of a drive of a workpiece. It is shown that the formation of the undulation of the butt in contour cutting occurs at the initial moment of contact of the jet with the workpiece and at the moment of changing the direction of motion of the workpiece. Practical value. A mathematical model is proposed taking into account the dynamics of the billet under the action of the hydrodynamic shock load, the dynamics of the feed drives and the phenomenon of the high-frequency influence of the abrasive particles. It is suggested to evaluate the quality of transient processes on the basis of an imitation model of hydroabrasive cutting. References 26, figures 11.
Authors and Affiliations
S. Kovalenko, V. Оrel, A. Salenko
Keywords
Related Articles
- EP ID EP660302
- DOI 10.30929/1995-0519.2018.4.56-68
- Views 67
- Downloads 0
STUDY OF PLANAR DEEP-SEAL THE CONCRETE MIXTURES VIBRATION EXCITER CIRCULAR OSCILLATION IN THE OPERATING MODE
Purpose. The purpose of the article is to study rational parameters of the planar deep seal of concrete mixtures with vibration exciter of circular vibrations in the operating mode. Methodology. A fundamentally new desig...
A COUPLE OF COLLECTIVE UTILITY AND MINIMUM PAYOFF PARITY LOSS RULES FOR REFINING NASH EQUILIBRIA IN BIMATRIX GAMES WITH ASYMMETRIC PAYOFFS
Purpose. For furthering the known approaches to the Nash equilibria refinement, an approach should be suggested that could exploit more than just one technique of operating over payoffs in bimatrix games. The payoffs mus...
CONCEPTUAL BASIS FOR THE DEVELOPMENT OF COMPLEX MONITORING SYSTEM ZONE RADIATION ACCIDENTS
Purpose. Study of the optimal method of comprehensive and continuous operational monitoring environmental ra- diation and the environment to obtain the required volume of reliable high technology information. Methodology...
MODERNIZATION OF SOLID WASTE CRUSHING EQUIPMENT
Purpose. In the light of the urgency of improving energy saving of the technological processes of solid waste management in Ukraine, the purpose of the work is modernization of equipment for secondary raw materials proce...
DEACTIVATION OF OIL AND GAS EQUIPMENT CONTAMINATED WITH SALTS OF RADIOACTIVE ISOTOPES
Purpose. To develop an environmentally safe and cost-effective method for cleaning oilfield equipment from radio-active sediments and the technology for its implementation. To justify the choice of the chemical method of...