Reliability and Construct Validity of the Malay Version of the Cyclist Motivation Instrument (CMI)
Journal Title: Journal of Science and Cycling - Year 2014, Vol 3, Issue 3
Abstract
With the increase interest in cycling, there is a need to understand what motivate cyclist to cycle. The Cyclist Motivation Instrument (CMI) has been shown to be a valid and reliable instrument to measure the motivation factors elsewhere. The present study was to assess the reliability and construct validity of the Malay version of the CMI among cyclists in Kuching, Sarawak, Malaysia. A total of 180 cyclists consented and participated in the study and were administered the Malay version of the CMI. Back translation method was used to ensure the face validity of the questionnaire. Reliability was determined using Cronbach’s alpha for internal consistency. Construct validity was assessed using exploratory factor analysis. The internal consistency for all components was satisfactory with Cronbach’s alpha coefficients of 0.799 to 0.880 and therefore confirmed the adequacy of these components. Exploratory factor analysis using Principal Component Analysis with a Varimax rotation showed 32 items were loaded into six factors orthogonal soluation with 67.8% of the variance. In conclusion, all components of CMI were found to be reliable and valid for determining factors motivating cyclists to cycle. Further analyses using confirmatory factor analysis and convergent validity would be ideal.
Authors and Affiliations
Cheah W Lian| Department of Community Medicine & Public Health, Faculty of Medicine and Health Sciences, University Malaysia Sarawak, Helmy Hazmi| Department of Community Medicine & Public Health, Faculty of Medicine and Health Sciences, University Malaysia Sarawak, Emmanual R Razali Lukas| Faculty of Medicine and Health Sciences, University Malaysia Sarawak, Irvy E Joannes| Faculty of Medicine and Health Sciences, University Malaysia Sarawak, Jaeverny H Berry| Faculty of Medicine and Health Sciences, University Malaysia Sarawak, Luther Lim| Faculty of Medicine and Health Sciences, University Malaysia Sarawak
Keywords
Related Articles
- EP ID EP2894
- DOI -
- Views 411
- Downloads 22
Reliability of power meter calibration by mathematical modelling of treadmill cycling
New power meters that are installed on various parts of the bike entered the market recently. Calibration of power meters is essential to ensure correct power output readings for testing and training. The use of a dynami...
Bike fitting: finding an optimum between performance and overuse injuries prevention? Influence of saddle fore-aft position on knee joint forces
The Union Cyclist International (UCI) regulates saddle setback - ‘ the tip of the saddle shall be a minimum of 5 cm to the rear of a vertical plane passing through the crank axis but no maximum is recommended’ - while t...
Three ways of assessing the forces at the knee and ankle while cycling
The analysis of the biomechanics of the leg while cycling is based on assumptions that make the calculations easier or faster. Most of the models and optimisations based on the dynamic chains introduced by Gonzalez & Hul...
Spectral properties of muscle activation during incremental cycling test
It is uncertain whether fatigue and workload would affect muscle recruitment during cycling. To infer on changes in priority for recruitment of motor units, we assessed the combined effects of fatigue and workload during...
An optimal control approach to the high intensity interval training design
Prediction of the acute response induced by various training protocols is of great importance when looking for a systematic approach in designing high intensity training (HIT) sessions. The prediction of some of the inde...