Research of the Parameters of Cut For the Machining of the New Concretes
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2017, Vol 7, Issue 6
Abstract
The composite materials are largely used (aeronautical), because of their advantageous mechanical properties (weight ratio/resistance). Because of the complexity of the phenomena presenting the zone of cut, current knowledge on their machining is limited and prevents their optimal use. From their constitution, these materials pose many problems during their machining. The objective of this study is to seek the parameters of cut during the composite machining of materials Concrete High efficiency (HPC) and Concrete Fiber High efficiency (HPCF). The latter are proposed for the manufacturing of the molds to carryout composite material parts, but the materials used for the manufacturing of the molds of the composite material parts like polyester, silicone and resin epoxy etc., do not resist to high temperatures, and also to analyze the behavior of the composite concrete during machining. Allowing to avoid the appearance of the defects (heating and wear of the cutting tool). An experimental design of machining of some tests was defined for the research of the parameters of cut (cutting speed Vc, depth of cut ap and advances by turn f). The variation of the parameters of cut for each test showed that machining after treatment, caused problems at particular level as in cutting tools and the appearance of the quoted defects.
Authors and Affiliations
A. Chaoufi, M. Zaoui, S. Tafraoui
Keywords
Related Articles
- EP ID EP254587
- DOI -
- Views 100
- Downloads 0
Classification of Roller Bearing Faults using Iterative Classifier
Bearings play an important role in power transmission systems and to ensure healthy functioning to get the best output. Therefore, a frequent and reliable inspection scheme needs to be employed to intervene before any cr...
A UNIFIED APPROACH FOR GENERALIZED MINIMUM VARIANCE CONTROLLER FOR LINEAR TIME-VARYING SYSTEMS
We study single input and single output stochastic linear time-varying systems and develop a unified approach for generalized minimum variance controllers. The plant to be controlled is a time-varying controlled autoregr...
Experimental Investigation of Heat Transfer Characteristics of the Heat Pipe
The rapid development of electronic industries and increasing processing speed of components, decrease the heat transfer surface area. This generates terribly high heat fluxes, leading to massive temperature rises. To re...
An Indian Earth Station Visibility Aspects for Near Real-Time Tsunami Monitoring
Research on the possibility of detecting a Tsunami event in the Bay of Bengal is being conducted at Jain University, Bangalore, considering the possibility of microwave altimeter configured on a number of small satellite...
Design and Analysis of Two Throat Wind Tunnel
To aid in understanding the concepts of aerodynamics, wind tunnels are used. The aim of this paper is to design and analyze a two throat supersonic wind tunnel to give a better start-up condition at supersonic speeds. As...