Research on Modeling of Land Leveling Problem
Journal Title: International Journal of Engineering Innovations and Research - Year 2018, Vol 7, Issue 4
Abstract
In this paper, how to choose the appropriate position and excavation depth in a piece of mountain was studied, so that the total amount of earth and stone was the smallest when the total cost of filling and excavation was saved as much as possible. The idea of grid method and limit differential was used, and more advanced data was obtained by interpolation from adjacent elevation points by using MATLAB software. According to the elevation of the design site in the actual elevation of the mountain area, the filling depth or the excavation height is calculated. According to the rectangular volume formula, the earthwork volume of the filling and excavating area in each grid could be obtained. The sum of the two was the total filling amount and the total excavation amount. When solving the problem of the position of the plane of the site, the position coordinates were represented by the points in the matrix, and then each point was traversed in turn by the enumeration method until the point with the smallest amount of earth and stone was found in consideration of the minimum total cost of filling and boring, thereby the area and altitude of the entire site were determined.
Authors and Affiliations
Xue Yao
Keywords
Related Articles
- EP ID EP498040
- DOI -
- Views 121
- Downloads 0
Numerical and Experimental Study of Evaporation of Liquid Effluent Flowing on an Inclined Plate
This work deals with the recovery of liquid effluent by thermal evaporation. The effluent is a digestate of pig manure which is subjected to anaerobic digestion and phase separation by centrifugation. Its dry matter is a...
A Bayesian Approach to Process Model Evaluation in Short Run SPC
With the availability of Big Data in manufacturing, historical data to initially characterize a process is available in abundance. In fact, evaluating and selecting the best-fitted data set replaces data availability as...
Investigation of Intake Boost Pressure Effects on Performance and Exhaust Exergy of a Natural Gas Fueled HCCI Combustion Engine
To increase thermal efficiency of Internal Combustion (IC) engines and follow emissions regulations, new combustion strategies should be used. Homogeneous Charged Compression Ignition (HCCI) engine is one of the advanced...
Simulating Vector Control Driver using Maximum Torque Strategy on Current Permanent Magnet Assisted Synchronous Reluctance Motor
Permanent Magnet Assisted Synchronous Reluctance Motor is one of the new motors introduced in transportation industry, which have been introduced as a possible tractions motors in hybrid electric vehicle applications. Ac...
Reducing Power, Leakage of Standard-Cell Design using Stack Transistor Logic Design
In this paper, a low leakage power optimizes CMOS layout designs. The approach is base on series-connected stack transistor technique. At first, the basic logic gate with conventional CMOS design and stack transistor bas...