RESEARCH ON USE OF LOW CONCENTRATION INVERSE SOLUBILITY POLYMERS IN WATER FOR HARDENING MACHINE COMPONENTS AND TOOLS
Journal Title: EUREKA: Physics and Engineering - Year 2018, Vol 0, Issue 2
Abstract
There is an optimal water concentration of inverse solubility polymers ( 1 %) where in many cases film boiling is absent. Based on accurate experimental data of French and data of authors, it was shown that during quenching from 875 oC in cold water solutions of optimal concentration film boiling is completely absent for those steel parts initial heat flux densities of which are below critical value. It is established that initial heat flux density decreases with increase sizes of tested samples. Initial process of quenching (formation of boundary boiling layer), which makes further history of cooling, is not investigated deeply and widely yet enough. When film boiling is absent, mathematical model includes only transient nucleate boiling process and convection. In this case, cooling time within the transient nucleate boiling process can be calculated using average effective Kondratjev numbers Kn. They were evaluated for inverse solubility polymers depending on their concentration and sizes of tested samples. As a result, an improved technology of hardening large gears and bearing rings is proposed by authors. Its essence consists in interruption of accelerated cooling or turning off agitation of quenchant when dissolving of surface polymeric layer starts. Examples of performing improved technology are provided by authors. Developments can be used by engineers to switch from carburized large gears quenched in oil to gears made of optimal hardenability steel and quenched in water solutions of optimal concentration.
Authors and Affiliations
Nikolai Kobasko, Anatolii Moskalenko, Volodymyr Dobryvechir
Keywords
Related Articles
- EP ID EP669016
- DOI 10.21303/2461-4262.2018.00582
- Views 321
- Downloads 0
RATIONAL CHOICE OF TWO-SUPPORT SPINDLES FOR MACHINING CENTERS WITH LUBRICATION SYSTEM
In the multivariate design mode, based on the effective parallel design facilities, the rational choice of the design of the two-support spindle for the machining center is the main aim of this article. A modified scheme...
ANALYSIS OF UKRAINIAN DIAGNOSTIC ARTICULATION TABLES
The problem of creating Ukrainian diagnostic tables for the testing of hearing impaired people has not yet been resolved. The article dedicated to the linguistic material of existing articulation tables. The basic method...
RESEARCH OF THE INFLUENCE OF LOW-FREQUENCY AND HIGH-FREQUENCY ACTIONS ON PROCESSING OF TECHNOLOGICAL ENVIRONMENTS
The processing of various vibrational low-frequency and cavitation high-frequency actions by their rheological properties is studied. A mathematical model of the motion of particles of a technological environment is dete...
METHOD OF OBTAINING APPROXIMATE FORMULAS
The two-parameter method of approximating the sum of a power series in terms of its first three terms of the expansion, which allows one to obtain analytic approximations of various functions, decomposes into a Maclaurin...
NON-TRADITIONAL CALCULATIONS OF ELEMENTARY MATHEMATICAL OPERATIONS: PART 1. MULTIPLICATION AND DIVISION
Different computational systems are a set of functional units and processors that can work together and exchange data with each other if required. In most cases, data transmission is organized in such a way that enables...