Safety and Arming Devices in Fusing System
Journal Title: Problemy Mechatroniki. Uzbrojenie, lotnictwo, inżynieria bezpieczeństwa - Year 2011, Vol 2, Issue 3
Abstract
The requirements for safety and arming devices of fuses according to the binding norms were presented in this paper. Moreover the basic types of explosive train interrupting devices and new tendencies in the design of safety devices in electronic fuses were described. In the last part of the article the preliminary conception of safety and arming device for new mortar proximity fuse was presented.
Authors and Affiliations
Rafał BAZELA, Mariusz MAGIER
Keywords
Related Articles
- EP ID EP62882
- DOI -
- Views 64
- Downloads 0
Options for Increasing the Safety and Improvement of the Protection of Military Mobile Technology
Military vehicles and equipment should be designed with regard to ergonomics, which is important for the protection of the crew. Reliable protection can be achieved by constant technological progress and the improvement...
PMN, PMN-2 and PMF-1 Landmines Detection Using Active Infrared Thermography with Microwave Excitation
In this paper, active infrared thermography is used to detect antipersonnel landmines: PMN, PMN-2 and PMF-1. Mentioned landmines have very low metal content and their casings are made of plastic, therefore are considered...
Rocket Motor with Composite Casing
The article presents the results of work concerning a two-stage rocket motor. In the first step tested stationary the charge rocket motor with the ignitor and the nozzle system in the ballistic chamber was tested. The t...
Deposition and Analysis of DLC Thin Films Obtained on 7075 Aluminum Alloy
In this study a-C:H (hydrogenated amorphous carbon) thin films were deposited on the 7075 Al alloy without and with admixture gas (N2) using a DC CVD (direct current chemical vapor deposition) method. The structural and...
Investigations of the Influence of Ignition on the Dynamic Vivacity of Propellants
The paper presents an attempt to determine the dynamic vivacity functions of propellants with taking into account a parallel burning of the black powder igniter and the tested propellant. The approach is based on present...