Seismic modelling as a tool for optimization of downhole microseismic monitoring array

Apply

Seismic modelling as a tool for optimization of downhole microseismic monitoring array

Journal Title: Geology, Geophysics & Environment - Year 2016, Vol 42, Issue 1

Abstract

Hydraulic fracturing processes employed to release natural gas accumulations trapped in shale formation causes cracks in fractured media occurred as microseismic events. Those events can be detected with either surface or downhole monitoring technique. One of the advantages of downhole microseismic monitoring technique is the relative high detection moment magnitude threshold, compared to surface and quasi surface arrays (Maxwell 2014). The epicenters of detected microseismic events are located with certain accuracies (Eisner et al. 2010). The uncertainties in location are mainly caused by simplification of a very complex geological structure, geometry of the monitoring network, arrival time pick uncertainty and naturally selected processing method. The correct assessment of macroseismic events locations with their uncertainties is the key to proper interpretation of the results. In this study, authors present an analysis of optimizing geometry of the downhole microseismic monitoring array minimalizing location error and taking into account level of detectability. To achieve this goal, several different downhole array geometries were tested. The study is located in Northern Poland where active exploration of shale gas deposits takes place. In the investigated area three wells are located, one vertical (W-1) and two horizontal, which have been drilled in the same azimuths but different direction and slightly different depths (W3H – deeper and W2Hbis – shallower). As there is possibility that these wells will be stimulated in close period of time, the chosen array placed in the monitoring well should be optimal for depths. As Eisner stated in his work, best downhole array should have to consist of 3C sensors placed below and above of the planed depths of stimulation to reduce uncertainty of the event locations (Eisner et al. 2009). Both treatment wells have relatively high horizontal distance, which results with high distance between receivers and possible events (in ranges between 500 m to 1700 m), which is quite high compared to literature examples (Warpiński & Natl 1994). To perform this analysis, GeoTomo MiVu TM Microseismic Processing System was used, which includes a Vecon modeling engine. This software has been granted to AGH UST for research and educational purposes. The passive seismic modelling was done with GRTM method (generalized reflection transmission coefficients) (Kennet 1980). This kind of mixed procedure is relatively fast to perform and allows checking many different configurations of downhole array. Based on the 3D seismic survey provided by PGNiG in the investigated area authors have decided to use simple layered velocity model which sufficiently describes the local geological conditions. The synthetic microseismic events were located using TGS (Traveltime Grid Search) algorithm available in MiVu software. Based on presented analysis authors were able to choose optimal geometry of downhole micro seismic array for both prospective intervals which fulfill condition of being good compromise between costs and location accuracy of possible events.

Authors and Affiliations

A. Pasternacki, E. Święch, T. Maćkowski

Keywords

A characterisation of the geothermal potential of the Muschelkalk deposits’ location, with the prospective of its utilization in balneology and recreation (southern Poland)

Analysis of the geothermal potential of the Muschelkalk deposits was carried out from the point of view of utilising hot groundwater in balneology and recreation. As a result of a number of analytical studies, the area s...

EP ID EP204533
DOI 10.7494/geol.2016.42.1.112
Views 68
Downloads 0