SIMULATION & DESIGN OF TOUCH TONE DIAL TELEPHONE (DTMF 8870) CHIP IN HDL ENVIRONMENT
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 0, Vol 5, Issue 1
Abstract
The communication switching system enables the universal connectivity. The universal connectivity is realized when any entity in one part of the world can communicate with any other entity in another part of the world. In many ways telecommunication will acts as a substitute for the increasingly expensive physical transportation. The telecommunication links and switching were mainly designed for voice communication. With the appropriate attachments/equipments, they can be used to transmit data. A modern society, therefore needs new facilities including very high bandwidth switched data networks, and large communication satellites with small, cheap earth antennas. Speed and size are two important factors while designing the electronic system. It’s Speed of operation and flexibility to modify, measures the performance of the system operation. Traffic handling capacity is an important element of service quality and will therefore play a basic role in this choice Microprocessor/microcontroller (MPMC) system can handle sequential operations with high flexibility and use of Field Programmable Gate Array (FPGA) can handle concurrent operations with high speed in small size area. So combined features of both these systems can enhance the performance of the system. High Performance Hybrid Telephone Network System (HTSS) is designed using combination of stored program control (SPC) and VLSI technology. Touch tone receiver follows DTMF (Dual tone Multifrequency) concept and Time division multiplexing is used for the call establishment for inter and intra communication.
Authors and Affiliations
Sachin Sangal
Keywords
Related Articles
- EP ID EP138377
- DOI -
- Views 60
- Downloads 0
SIMULATION OF ELECTROMAGNETIC FIELD FROM MICROWAVE RECTANGULAR WAVEGUIDE TO CIRCULAR IN TRANSITION DEVICES
New mathematical models of electromagnetic field of microwave rectangular and circular waveguides have been established in polar coordinate system. Ritz and Galerkin methods for solving mathematical models have be...
DETERMINATION OF MATERIAL FOR SHAFT DESIGN USING TOPSIS BASED TAGUCHI METHOD
The shaft is a mechanical accessory where many applications like machines, automobiles, aircrafts etc., must have a proper design of the shaft, in-order to have the efficient transmission of power from one element...
NUMERICAL STUDY ON HEAT TRANSFER OF TURBULENT DUCT FLOW THROUGH RIBBED DUCT
Ribs have been used as a tool to enhance heat transfer by increasing the level of turbulence mixing in the flow. Enhancing heat transfer surface are used in many engineering applications such as gas turbine blade coolin...
Effect of Refuse Dump on Underground Water Quality
The major source of water in EMENE, the study area is rain, streams and well water. Waste management has been a problem in Nigeria and so many developing nations. Most organic pollutant and pollute our underground...
Three Phase Power Factor Correction Using SEPIC In DCM With Isolation
The improvement of power quality are required in AC-DC converters in terms of power factor correction. The PF is improved by reduction of total harmonic distortion at input of ac supply. Also high PF needed precis...