slugInvestigation on the Effect of Process Parameters For EN31 material By EDM using full factorial method
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2014, Vol 2, Issue 5
Abstract
This paper presents the results of experimental work carried out in electrical discharge machining (EDM) of EN31 using tool materials namely aluminium The machining process was carried out at three different supply current levels (17Amps, 21Amps, 28Amps) , pulse-on time (45μsec, 55μsec, 65μsec), and pulse off time (30μsec, 45μsec, 60μsec) their influence on surface roughness, material removal rate, tool wear rate. The optimal setting of the parameters are determined through experiments planned, conducted and analyzed using the full factorial method. Key words: Electrical discharge machining (EDM) . Material removal rate, surface roughness, tool wear ratio. Full factorial method, and Design Expert7.01.
Authors and Affiliations
Vaibhav Darji, Prof Yashesh. A. Darji
Keywords
Related Articles
- EP ID EP18003
- DOI -
- Views 266
- Downloads 10
Behavioural Comparison of Geometrically Different Steel Plate Shear Walls
Steel Plate Shear Walls (SPSWs) have been used as efficient and widely constructed primary lateral force resisting system particularly in areas of high seismic hazard in several modern and important structures. Signific...
Design and Implementation of UART with DFT-BIST for Data Communication
The increasing growth of VLSI technology has resulted in the difficulty of testing. Design and test engineers have no choice but to accept new responsibilities that had been performed by groups of technicians in the pre...
Alcohols as Alternative Fuels for Diesel Engines: A REVIEW
The fuel which is used in Internal Combustion engines meant for transportation applications will satisfy all the requirements of cost effectiveness, maximum thermal efficiency, excellent engine performance, and still re...
Fault Diagnosis and Monitoring In Wind Turbine Using Can Bus
This paper is a CAN based architecture intended for the purpose of monitoring and fault diagnosis of wind turbine. CAN is a memo based protocol designed specifically for automotive, late aerospace, industrial automation...
RFID Technology for IOT Based Meal Management System
The current systems of Meal Management in the canteens can be upgraded using Internet of Things (IoT) paradigm involving RFID technology with the purpose to make the existing system faster and efficient. RF identificati...