Some Facts Resulting from the Key Variables Used in the Description of the Recuperative Heat Exchangers
Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2018, Vol 68, Issue 3
Abstract
There are the various types of heat exchangers. The selection of the heat exchanger right type is the first basic assumption for its optimal operation. The heat exchanger calculation itself is another prerequisite for its optimal operation. This article deals with the variables which are usually used to describe the stationary operation of any recuperative heat exchanger with two incoming and two outgoing streams. The knowledge of these variables, including the facts resulting from them, is necessary not only from the point of view of the calculation but also from the point of view of the evaluation of the experimental data of any heat exchanger. The variables values needed for the calculation of heat exchangers, so-called key variables, must always fall within the values range determined on the basis of generally valid knowledge about heat exchangers. The article also deals with the determination of the limit values defining the values range of these key variables.
Authors and Affiliations
Štefan Gužela and František Dzianik
Keywords
Related Articles
- EP ID EP43960
- DOI https://doi.org/10.2478/scjme-2018-0038
- Views 212
- Downloads 0
Proposed Robot Scheme with 5 DoF and Dynamic Modelling Using Maple Software
In this paper is represented Dynamical Modelling of robots which is commonly first important step of Modelling, Analysis and Control of robotic systems. This paper is focused on using Denavit-Hartenberg (DH) convention...
Detection and Modeling Vibrational Behavior of a Gas Turbine Based on Dynamic Neural Networks Approach
During the gas turbine exploitation the presence of small defects can cause very high vibration amplifications, localized on the components of this rotating machine. For this, a diagnostic process is necessary for deci...
Simulation Process Deep Drawing of Tailor Welded Blanks DP600 and BH220 Materials in Tool With Elastic Blankholder
The high-strength steels and tailor welded blanks (TWB) are applied in construction of cars parts to reduction of cars weight [1, 2]. The application of these materials brings possible complicatons during the forming w...
Static Balancing of Robot Mechanisms and Manipulation Devices
The paper deals with static balancing of various kinds of mechanisms and manipulation devices using spring balancing mechanisms. In case of parallelogram robots and manipulation mechanisms a spring balancing mechanism...
Methods of Testing of Sound Insulation Properties of Barriers Intended for High Frequency Noise and Ultrasonic Noise Protection
Two test stands for determining sound insulation in the frequency range above 5 kHz were made. One consisted of two horizontally adjacent reverberation rooms and a special source of high frequency sounds and ultrasound...