Static and Dynamic Analysis of Stress and Deformations of Răstoliţa Dam
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2016, Vol 39, Issue 4
Abstract
Large Dams are a particularly important case of seismic risk assessment. On the one hand, the dams themselves have a high value, having implications for the whole economy, through the production of electricity, water supply systems for irrigation and flood prevention etc. On the other hand, structural damage of a dam can lead to major disasters, the population exposure to effects caused by sudden floods. The situation in Romania is such that attention should be paid to the future safety of existing dams. The first reason is that these dams were designed and constructed on the basis of technical rules, which the majority are no longer in force; a second reason is the major climate changes in the last period, which have led to the accumulation of a large volume of water in increasingly large lakes. A third reason is, logically, the length of existing dams. In this paper is analysed the stress - deformation state that occurs in Răstoliţa dam body according to the type of rockfill; calculations were done for two cases, namely the completion of construction and, respectively, at the first filling of dam with water. The results show that after completion of construction, the maximum settlement is recorded in the central area of the dam, below the middle third; horizontal displacements of downstream prism are significantly higher compared to deformations of the upstream prism, in the area where the used material has a higher compressibility. Maximum principal normal stress registers some local distortions within acceptable limits; minimum principal normal stress presents important gradients in the contact zone downstream dam slope in the Ist stage with tuff-pyroclastic embankment layer and also in the first three layers of intercalated filling disposed near the slope. Stress increases due of hydrostatic pressure after the first filling does not lead to occurrence of stress concentrations in other zones than those reported at the completion of construction.
Authors and Affiliations
Mihaela TODERAŞ, Ciprian DANCIU
Keywords
Related Articles
- EP ID EP576965
- DOI -
- Views 100
- Downloads 0
Effect of Fluidized- Bed Carburizing on Mechanical Properties and Abrasive Wear Behavior of Sintered Steels
In this paper is studied the influence of fluidized bed carburizing of sintered steels, for three different types of powder. Carburization is one of the most popular variety of temochemical treatment. Usually, carburizat...
Biological Behavior and Corrosion of Prosthetic and Orthodontic Titanium Implants
Titanium and its alloys are used in dentistry for implants because of their unique combination of chemical, physical, and biological properties. For dental implants, biocompatibility depends on mechanical and corrosion/d...
Researches Regarding the Influence of Steam Oxidation on Sintered Alloys Properties
In this paper is studied the influence of steam treatment applied on sintered steels and the mechanical properties and abrasive wear behavior for two different types of powder. Steam treatment was carried out at temperat...
Cu-Ag-Rear Metals for Wires: Processing and Characterisation
Cu based alloy microalloyed with rear metals (RM) (in our case, sample with Nb) for wires were prepared by two different techniques arc-melting and mechanical alloying. Microstructure characterisation was carried out by...
Analysis Tools for Sustainable Management of Cell Phone Waste for Metals Recovery
A modern cell phone contains over 60 metals, combined physically or chemically and in some cases covered with various types of plastics, ceramics, etc. For recycling, each metal from the device needs to be analyzed indiv...