STATIC AND DYNAMIC FRICTION CHARACTERISTICS OF POLYMER COMPOSITES INTENDED FOR REGENERATION OF TOOL GUIDES
Journal Title: Tribologia - Year 2014, Vol 253, Issue 1
Abstract
The paper presents the results of static and dynamic friction force measurements for chemo-setting metal-polymer composites, made from epoxy resin. The composites are intended for the regeneration of the sliding guides in cutting machines. The composites with various qualitative and quantitative contents were tested. The main powder filler was iron powder of specific chemical content and granulometric distribution obtained by the reduction method. The composites were modified by the addition of anisotropic solid greases (graphite and molybdenum disulphide) one or both. The composites were cross-linked by means of aliphatic polyamine (triethylenetetramine). The static friction coefficient in dry conditions was measured by means of a special test rig with a tribosystem adapted for dry friction investigation under reciprocation motion, which is the typical motion of the guiding systems of cutting tools. The measurements were performed under various unit pressures (0.1, 0.5, 1.0, 1.5, and 2.0 MPa). The effect of the type of friction modifiers and friction couple load on the static and dynamic friction force of metal-polymer composite-steel tribosystems was tested. As a reference, the static and dynamic characteristics of the steel-steel tribosystem were investigated. Based on the obtained test results, it was concluded that static and dynamic friction coefficient depends on the type of modifiers used. The most beneficial results and stick-slip phenomena reduction were obtained for the composites containing mixed anisotropic solid lubricants.
Authors and Affiliations
Zbigniew PAWELEC, Piotr KOWALEWSKI
Keywords
Related Articles
- EP ID EP263774
- DOI -
- Views 35
- Downloads 0
TRIBOLOGICAL PROPERTIES OF TI/A-C:H NANOCOMPOSITE CARBON BASED COATINGS
The paper presents the results of mechanical and tribological tests of Ti/a-C:H nanocomposite carbon coatings and a-C:H hydrogenated carbon coating. All coatings were deposited by magnetron sputtering technique at variou...
HIGH TEMPERATURE TRIBOLOGICAL PROPERTIES OF Fe-Al ALLOYS
This research was focused on high temperature tribological properties of Fe-Al alloys. Powder and cast FeAl alloy was used in this study. The influence of the alloy morphology on its tribological properties is discussed....
PORÓWNANIE ODPORNOŚCI NA ZUŻYWANIE ŚCIERNE STALI HARDOX 500 i 20MnCr5
W pracy przedstawiono wyniki badań eksperymentalnych dotyczących odporności na zużywanie ścierne stali Hardox 500 i stali 20MnCr5 poddanej obróbce cieplno-chemicznej. Stale te często stosuje się na elementy maszyn rolnic...
WPŁYW MODYFIKACJI POWIERZCHNI OPOROWEJ NA PARAMETRY PRACY WZDŁUŻNEGO ŁOŻYSKA ŚLIZGOWEGO SMAROWANEGO CIECZĄ MAGNETOREOLOGICZNĄ
Ciecze magnetyczne należą do klasy materiałów sterowalnych. Oddziaływanie polem magnetycznym na tego typu substancje skutkuje zmianą ich struktury wewnętrznej i w efekcie niemal natychmiastową zmianą właściwości reologic...
Badanie zmian lepkości cieczy ferromagnetycznych poddanych działaniu stałego pola magnetycznego
W pracy przestawiono wyniki badań lepkości wybranych cieczy ferromagnetycznych poddanych działaniu stałego pola magnetycznego przy różnych wartościach strumienia indukcji magnetycznej. W badaniach uwzględniono wpływ szyb...