Studies of Efficiency of Tie Rod Usage for Masonry Wall Strengthening
Journal Title: Металлические конструкции - Year 2018, Vol 24, Issue 3
Abstract
In the paper the influence of nontensional horizontal steel tie rods installation in a building perimeter on vertical and horizontal deformations of bearing walls of stone buildings is considered. Buildings of large blocks and bricks, loaded with constant and temporary loads were taken as initial data. By the way of the special effects it has been given ground vertical shifts which are accorded to mould radii of displacement through underworking. The stress-strain state of buildings was determined on the basis of numerical calculations using 3D models. The dependence of wall deformations from an area of ties to be installed at each floor level was obtained. For generalization the values of deformations were received as a function of an uneven relative settlement. It has been determined that the horizontal deformations is reducing up to 1,5…2,5 times (efficiency factor of 0,67…0,4) while a relative settlement does not exceed of 0,004. The research has demonstrated a usage of untensioned tie rods to be not effective in all for masonry wall strengthening.
Authors and Affiliations
Vadim Gubanov, Yana Zikii, Alina Pchelenko
Keywords
Related Articles
- EP ID EP536603
- DOI -
- Views 111
- Downloads 0
Rational structural decisions load-bearing supporting structures dome diameter 15 m
Based on a critical analysis of the experience of the design and construction of domes, the most common designs bearing dome structures have been determined. The calculation of the domes and the analysis of the stress an...
Studies of Efficiency of Tie Rod Usage for Masonry Wall Strengthening
In the paper the influence of nontensional horizontal steel tie rods installation in a building perimeter on vertical and horizontal deformations of bearing walls of stone buildings is considered. Buildings of large bloc...
Metal multifaceted poles as a base of the urban infrastructures
The article deals with national and the foreign experience of metal multifaceted bent conical poles (tubes) at creation of tower structures directed to a providing of livelihood needs of modern cities. The analytic revie...
Numerical Determination of The Probability of Failure of a Bent Steel Rod
In this paper, we consider three different methods for calculating the probability of failure (the method of two moments, statistical tests and Monte Carlo) of the rod element. As an example, a calculation is made for a...
Influence of Design Features of Power Lines to the Technology of their Construction
General information of the extent of backbone and interstate overhead power lines has been given. The classification of pylons has been presented. The advantages and disadvantages of the materials used for the supports h...