STUDY OF THE IMPACT OF INCREMENTAL TECHNOLOGY ON MECHANICAL AND TRIBOLOGICAL PROPERTIES OF BIOMATERIALS
Journal Title: Tribologia - Year 2017, Vol 273, Issue 3
Abstract
The latest method for creating denture replenishment in CAD / CAM systems is Direct Metal Laser Sintering (DMLS) technology. With the use of DMLS, prosthodontics, implant prosthetics, and facial-cranialjaw surgery adapted to individual patient conditions can be realized. The aim is to evaluate the strength, microstructure, and tribological properties of Ti6Al4V and CoCrMo alloys obtained from DMLS technology in the aspect of therapeutic constructions. The conducted tests show that, in the DMLS technology, as compared to milling technology preceded by casting and forging or pressed powder and sintering, for the same percentage composition of elements, the micromechanical properties, microstructural and tribological change. This procedure, from which constructions for various dental applications are obtained, is the new technology preferred for making permanent restorations faced with ceramics, producing intravascular implants, and implants of the temporomandibular joint. It can be an alternative to conventional cast-based methods and CAD / CAM based milling.
Authors and Affiliations
Łukasz BOJKO, Wojciech RYNIEWICZ, Anna M. RYNIEWICZ, Marcin KOT
Keywords
Related Articles
- EP ID EP239468
- DOI -
- Views 64
- Downloads 0
FRICTIONAL PROBLEMS IN CONTINUOUSLY VARIABLE TRANSMISSION BELT DRIVES
The article describes the results of the research carried out on the evaluation of the influence of friction pairs (rubber belt – belt pulley in belt drive) on the ability to transmit power. In order to determine the cha...
CARBIDE LAYERS PRODUCED IN VACUUM CHROMIZING PROCESS ON STEEL SURFACE COVERED WITH NICKEL ALLOYS CONTAINING CARBIDE-FORMING ELEMENTS
In this paper duplex layers of the CrC+(Ni-W), the CrC+(Ni-Mo) and the CrC+Ni type produced on tool steel surface, in combined galvanic and vacuum chromizing processes, have been investigated. Studies of layers thickness...
Rolling contact fatigue life for elastic linear kinematic-hardening plastic material
Wpływ fluorowania powierzchni gumy na jej właściwości tribologiczne
W pracy przedstawiono wyniki badań wpływu modyfikacji, poprzez fluorowanie z fazy gazowej, powierzchni wulkanizatów na bazie kauczuków akrylowego (ACM), butadienowo-akrylonitrylowego (NBR) oraz jego uwodornionego analogu...
THE PROCESS OF FORMATION OF THE ADHESIVE CAVITIES UNDER OSCILLATORY MOTION
During the direct contact of metal-to-metal, complex tribological wear processes occur. One of the most important and the most problematic phenomena leading to irreversible changes in the geometric structure of the surfa...