Study of the Magnetic Field of a Permanent Magnet Synchronous Generator by using the Finite Element Method
Journal Title: Analele Universitatii "Eftimie Murgu" Resita. Fascicula de Inginerie - Year 2016, Vol 23, Issue 1
Abstract
The study shows the numerical simulation of the magnetic field for a permanent magnet synchronous generator prototype. Through the study, the OPERA software environment, a program based on the numerical computation using the finite element method and used for the virtual simulation of the synchronous generator prototype, is shown. This 5 kVA power, permanent magnet and low speed prototype is meant for uses in hydraulic driven applications, namely wind applications, and was performed within a cooperations between the Faculty of Automation and Computers and the Faculty of Electrical and Power Engineering within the “Politehnica” University of Timișoara.
Authors and Affiliations
Constantin Gabriel Dobrean, Marius Biriescu, Marțian Moț, Gheorghe Madescu, Marian Greconici
Keywords
Related Articles
- EP ID EP446853
- DOI -
- Views 98
- Downloads 0
The Study of chemical Inhomogenety Formation in Cast Ingots
This paper presents a study of chemical inhomogeneity formation indirect casting of a 6 to ingot, using the AnyCasting software (Var.3.10, 2009). The ingot was obtained from steel with a medium content of carbon alloyed...
Calculation of Digital Control Circuits using Scilab Environment
The paper presents the computing of digital control circuits using Scilab environment. It exemplifies the influence of the sampling time in case of a transfer system described by a PT3 element composed of one PT1 and one...
Tests Performed on Hydraulic Turbines at Commissioning or after Capital Repairs. Part II. Tests Per-formed on a 6.5 MW Kaplan Turbine
The paper presents the tests performed on a hydraulic turbine on commissioning, the devices, test methods and the results obtained from the respective tests, as well as the conclusions and recommendations resulted from t...
HydroHillChart – Francis module. Software used to Calculate the Hill Chart of the Francis Hydraulic Turbines
The paper presents the Hydro Hill Chart - Francis module application, used to calculate the hill chart of the Pelton, Francis and Kaplan hydraulic turbine models, by processing the data measured on the stand. After de-sc...
The Hill Chart Calculation for Francis Runner Models using the HydroHillChart - Francis Module Software
In practice, for the design of hydraulic turbines, laboratory tests performed on reduced scale models of turbines are recommended. The optimisation of a turbine model requires extensive experimental research on several v...