Study to Determine the Gaseous Emissions from the Combustion Gases
Journal Title: RECENT - Year 2014, Vol 15, Issue 43
Abstract
The paper presents some aspects about measurement of the pollutants emissions from a heat treatment plant. Responsibility belongs emissions monitoring equipment operators, environmental authorities and organizations involved (authorized organizations- companies, laboratories, operators are empowered to make measurements of emissions of air pollutants from large combustion plants). In this paper, the practical examinations were made in collaboration between author and the Monitoring Department from the Environmental Protection Agency of Brasov, conducted in a company’s "Metrom Industrial Park", the source of pollution was a tempering furnace fuelled by natural gas for heat treatment. Sampling points were: before and after the filter basket mounted on the exhaust gas inside the oven. It was used a gas analyzers TESTO 350 XL - a performance equipment to determine gaseous emissions from the combustion gases. All the determinations were done in special cells, following chemical reaction type Peltier. Analyzed gases are: SO2, CO, CmHn, O2, NO and NO2. Following the experimental determinations, it can be concluded that they exceeding the emission limit values for the indicator of carbon monoxide (CO), both before and after the filter, gives a hot-performing incomplete combustion.
Authors and Affiliations
Ioan MILOȘAN
Keywords
Related Articles
- EP ID EP94740
- DOI -
- Views 101
- Downloads 0
Experimental Platform for Simulation and Analysis of Systems States and Fault Diagnosis in Industrial and Logistics Systems
The present paper describes the development of advanced experimental platform, designated for modelling, simulation and analysis of technologic operations, systems states, and fault diagnosis realized in real and/or simu...
Web-Based Methodology for the Management of FMEA Projects
The Failure Mode and Effects Analysis (FMEA) is a technique for the management of the reliability and security of systems, products and processes that helps to identify the most important problems that can lead to their...
Sequence Logic Modules
The authors of the inventor certificate provide, to specialists in the field of sequential pneumatic commands, a new method and system, which have the following characteristics: they solve any sequential cycle of pneumat...
Laser Cladding of Metco 68F-NS-1 Cobalt Based Powder
This paper addresses to the laser cladding of cobalt base powder on AISI 5140 chromium steel. Experimental investigations are made to determine the influence of the scanning speed on the geometrical feature of the laser...
Evaluation of Operational Reliability in Industrial Sensors Control Systems via Stochastic Petri Nets (SPN)
The present paper describes the application of Stochastic Petri Nets (SPN) for analysis, modelling and evaluation of the operational reliability in industrial control systems. The SPN are applied for reliability modellin...