TEMPERATURE OF PLOUGHSHARE MATERIAL IN THE COURSE OF PLOUGHING
Journal Title: Tribologia - Year 2016, Vol 266, Issue 2
Abstract
The change of temperature of subsurface layer material of ploughshare, occurring in the course of fine sandy loam (8% moisture and temperature 15.3°C) cultivation, done with bed making plough, was determined. Measuring system with 10 temperature sensors built in the ploughshare material was used in the research. Temperature value was registered with frequency of 1 Hz. The increase of temperature of subsurface layer of ploughshare blade material used in soil was fast – time of temperature stabilization was, depending on location the place of measuring from 17 to 43 s. In the course of ploughing the most heated was the initial area of the attack of landslide part of ploughshare blade and area adjacent to field edge – from 42.6 to 47.3°C. The temperature of material of trapezoid part of ploughshare blade was 26.6 to 29.7°C. In the conditions of the conducted measurements the rate of cooling of the subsurface layer of ploughshare blade material as the result of its cooling was 0.007 to 0.028°C·s-1 while plough was not working, however while making U-turns was from 3 to 7 times higher. In the places where the material of ploughshare blade was more heated the rate of cooling was of course higher. Faster cooling of ploughshare blade during U-turns was probably the result of intensified cooling induced by plough movement in the air.<br/><br/>
Authors and Affiliations
Piotr KOSTENCKI
Keywords
Related Articles
- EP ID EP248211
- DOI 10.5604/01.3001.0010.7563
- Views 36
- Downloads 0
THE TRIBOLOGICAL PROPERTIES OF DLC COATINGS
The paper presents the results of a-C:H and a-C:H:W diamond-like carbon coatings deposited using the PACVD process. The topography, texture, and cross section analysis of the coatings were determined by applying profilom...
EVALUATION OF THE LUBRICATION EFFICIENCY OF GREASES ACCORDING TO CRITERION OF WEAR EXPERIMENTALLY DETERMINED AT VARIABLE VALUES OF MOTION PARAMETERS
The results of tribological investigations into the lubrication efficiency of greases in steel sliding pairs working in mixed friction conditions are presented. The lubrication efficiency was evaluated according to the c...
LABORATORY STUDIES OF THE INFLUENCE OF THERMAL CYCLING ON ANTI-WEAR PROPERTIES OF COMPOSITES USED IN BIOTRIBOLOGICAL FRICTION PAIRS
This paper presents the problems associated with changes in resistance to the tribological wear of light-cured polymer matrix ceramic composites (LC PMCCs) used in conservative dentistry and in dental prosthetics (fillin...
REDUCTION OF DRIVING FORCE IN SLIDING MOTION AS AN EFFECT OF LONGITUDINAL TANGENTIAL VIBRATION
The results of the analysis of the longitudinal tangential contact vibrations effect on friction and driving forces in sliding motion are presented in this paper. In experimental tests the variations of driving force dur...
TRIBOLOGICAL WEAR OF WHEEL RIMS IN RAIL VEHICLES IN OPERATING CONDITIONS
Wheel sets as elements determine the reliability and safety in railway traffic demand ensuring high technological and quality standards at the stage of production and exploitation. Not satisfying these conditions may res...