Testing Group of Helicoidal Expander – Electric Generator at Comoti Test Bench, Using Air Supplied by 3 Compressors Type CU128G
Journal Title: INCAS BULLETIN - Year 2012, Vol 4, Issue 4
Abstract
The paper describe a project dedicated to exploitation of natural gas, an important quantity of mechanical clean energy is loosed continuously by not using expansion energy in laminating process gas. A group of helicoidal expander – electrical generator was manufactured and tested. It is designed to produce electric energy for own facilities of a gas station or to supply local networks of gas distribution.
Authors and Affiliations
Niculae TOMA, Adrian UNGUREANU
Continuous thrust tangential or perpendicular to the flight direction on a given transfer trajectory in planar Circular Restricted 3-Body Problem
This paper presents a systematic study for analytical determination of thrust acceleration magnitude on a given trajectory for a case where the thrust is tangential or perpendicular to the flight direction. The problem h...
Bezier-curve Navigation Guidance for Impact Time and Angle Control
This paper addresses a novel impact time and angle control guidance law using a Bézier curve. The 2nd order Bézier curve consists of one control point and two boundary points; initial point P0, middle point P1 and end po...
Blowdown wind tunnel control using an adaptive fuzzy PI controller
The paper presents an approach towards the control of a supersonic blowdown wind tunnel plant (as evidenced by experimental data collected from “INCAS Supersonic Blowdown Wind Tunnel”) using a PI type controller. The key...
Tribological performance of the blend PBT and short aramid fibers
Polybutylene terephthalate (PBT) and its aramid fiber composite (10 wt.%) were investigated in order to measure their wear and frictional properties under variations of applied load (5 N, 10 N, 15N) and velocity (0.25 m/...
Professor Ion Stroescu pioneer of aeronautics and particularly of experimental aerodynamics