Testing of measurement instrument software with the purpose of conformity assessment
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 1, Issue 9
Abstract
<p>The analysis of the regulatory framework for testing measuring instruments (MI) software at the national level to determine its suitability for carrying out conformity assessment was conducted. Comparison of the general requirements of national normative documents and documents of international and regional organizations of legal metrology OIML and WELMEC was conducted. In particular, regarding the suitability of software for application and protection against unauthorized interference. It is found that the current national standard contains only general requirements for software protection and does not determine the methodology of software testing. This is important because the MIs, which are intended for use in the field of regulated metrology, must undergo a procedure for conformity assessment with the requirements of the technical regulations.</p>The main differences were identified and the necessary elements were established to achieve the presumption of conformity of the software with essential requirements of the technical regulations during conformity assessment of the MI. Requirements of normative documents concerning suitability for application and protection against unauthorized interference are identified. In order to specify requirements for software and to ensure compliance with the requirements of the software test method, the need for additional use of the requirements of the OIML D 31 and WELMEC 7.2 documents was established. The need to revise the current national standard for MI software testing was proved. The algorithm of testing of the MI software for conformity assessment was established and studied. The algorithm takes into account the requirements of international standards for the software life cycle and the quality system when developing the software. This will take into account all the elements necessary to achieve the presumption of conformity of software with the essential requirements of technical regulations
Authors and Affiliations
Oleh Velychko, Valentyn Gaman, Tetyana Gordiyenko
Keywords
Related Articles
- EP ID EP666224
- DOI 10.15587/1729-4061.2019.154352
- Views 127
- Downloads 0
Development of a sol-gel technique for obtaining sintering activators for engobe coatings
<p>We have developed a technology for manufacturing the glass ligaments-activators to intensify the sintering of ceramic materials, specifically engobe coatings. The comparative analysis has been performed into the glass...
Forecasting the estimated time of arrival for a cargo dispatch delivered by a freight train along a railway section
<p>This paper reports a method for predicting the expected time of arrival (ETA) of a cargo dispatch taking into consideration determining the duration at which a freight train travels along a railroad section where trai...
Development of methods for estimating the environmental risk of degradation of the surface water state
<p>We presented three new methods for assessment of the environmental risk of deterioration of a surface water state. We defined the ecological risk of deterioration of surface water at the state level as an addition of...
Establishing the patterns in anode behavior of copper in phosphoric acid solutions when adding alcohols
<p>We have investigated the anodic polarization dependences of the copper electrode in phosphate-alcoholic solutions. The dependences derived can be divided into regions, each of which corresponds to the course of certai...
Revealing special features of hydrodynamics in a rotor-disk film vaporizing plant
This paper reports the generalized results of computer simulation of physical processes at a rotor-disk film evaporating plant. Optimization of the operation mode cannot be achieved without establishing patterns in the c...