The bearing capacity of footings on sand with a weak layer
Journal Title: Geotechnical Research - Year 2017, Vol 4, Issue 1
Abstract
Minor details of the ground, such as thin weak layers, shear bands and slickensided surfaces, can substantially affect the behaviour of soil–footing and other geotechnical systems, despite their seeming insignificance. In this paper, the influence of the presence of a thin horizontal weak layer on the ultimate bearing capacity of a strip footing on dense sand is investigated by single-gravity tests on small-scale physical models of the soil–footing system. The test results show that the weak layer strongly influences both the failure mechanism and the ultimate bearing capacity if its depth is lower than about four times the footing width. It is found that the presence of a thin weak layer can cause decreases of the ultimate bearing capacity of up to 80%. Numerical simulations, by finite-element analysis, of the behaviour of the reduced-scale models are able to capture the failure mechanism and the ultimate bearing capacity correctly, only if the mean equivalent constant value of the secant angle of shearing resistance used in calculations is selected, taking into account the curvature of the shear strength envelope of the sand within the very low normal stress range existing in the tested models.
Authors and Affiliations
Maurizio Ziccarelli
Measurement, interpretation and recommended use of laboratory strength properties of fibrous peat
Peat deposits are complex natural formations encountered in many geographical areas. Peat itself is considered as a challenging geomaterial, with many aspects of its behaviour seemingly remaining enigmas. This state-of-t...
Mechanical behaviour of sand stabilised with colloidal silica
The response of sand stabilised with colloidal silica aqueous gel is examined in the laboratory, under direct shear, triaxial and normal compression loading, in comparison to that of untreated sand of similar density to...
The bearing capacity of footings on sand with a weak layer
Minor details of the ground, such as thin weak layers, shear bands and slickensided surfaces, can substantially affect the behaviour of soil–footing and other geotechnical systems, despite their seeming insignificance. I...
Research-oriented ground investigation projects at Changi, Singapore
The Changi East Reclamation projects in Singapore were implemented in five phases starting from 1991 and completed in 2005. Due to the excessive magnitude of settlement likely to occur over a long period of duration caus...
Seismic analysis of pile in liquefiable soil and plastic hinge
Liquefaction is one of the leading seismic actions that cause extensive damage to buildings and infrastructure during earthquakes. In many historic cases, plastic hinge formations in piles were observed at inexplicable l...