The Comparision of Energy Production of Monocrystalline And Policrystalline Solar Panel By Using The wirelessly And Measurement of Energy
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2017, Vol 12, Issue 6
Abstract
Today, electrical energy demand is increasing day by day. I need a situation like this, the signs of the development of the electric energy country came into being. Parallel does not increase. Electric energy production is growing as demand for electricity increases. In order to be able to be prevented by this condition, we can make the most of electricity energy. It uses a variety of methods to optimally consume consumed electricity. This study examines the energy production of solar panels at the forefront of renewable energy sources. In addition, remote measurement and control has been performed on the produced energy. For this, there are two types of solar panels widely used in the market, monocrystalline and polycrystalline solar panels are preferred. Two solar panels convert the sunlight into electricity. But the amount of electricity they produce is different. The most important reason for this cannot be used in production. For Ardunio preferred. Remote control was provided by adding a wireless modem to Ardunio's skirt card. The control and measurement distance remained the same with the modem limit. When reaching a distance of 1 kilometer in open areas, this distance is 300 meters in closed areas. If monocrystalline and polycrystalline solar panels are produced, if voltages and currents are produced, they are measured by sensors and then converted into digital data. This data is also shown on the designed website.
Authors and Affiliations
Asist. Prof. Riyad Şihab, Asist. Prof. Kamil Özcan, Asist. Prof. Sertaç Görgülü, Lec. Abdil Karakan
Keywords
Related Articles
- EP ID EP388510
- DOI 10.9790/1676-1206037682.
- Views 119
- Downloads 0
Design and Development of a Warning System for Early Season Control of Powdery Mildew Affecting Agricultural Crops.
The crop management system using Wireless Sensor Network (WSN) is a kind of an autonomous solution to plant disease detection, an essential and critical operation which affects yield, cost and environmental protection ag...
Load Shedding Strategy in Electrical Power System Using Under Frequency Relay
Stability of power system can be defined as its property which keeps several parameters in the balanced operating condition when sudden disturbances occur. In the stable operating condition, mechanical power input in the...
Wireless Energy Harvesting Using RF-Dc Module
This project presents an optimization of the Voltage doubler circuit in an energy conversion module for Radio Frequency (RF) energy harvesting system at both 900 MHz and 900Hz band. The function of the energy conversion...
A Study of Triangle Current Charge Method in Ni-MH Battery
This study propose the charging method from the triangle current charge method in Ni-MH battery. By using microcontroller board (PIC24FJ128GB110) to control the battery charging circuit. The charger recorded the battery...
Design Modeling and Simulation of Fuzzy Controlled Svc for Long Over Head Transmission Line
The basic control objectives of a power system are system voltage control, system frequency control, protection and economic operation. Reactive power control is a subset of overall system control and stability. A power...