The Comparison of Different Surface Preparation Methods in Terms of Shear Bond Strength of Tri-ceram Porcelaintitanium Alloy
Journal Title: Meandros Medical and Dental Journal - Year 2019, Vol 20, Issue 2
Abstract
Objective: Several studies have been made to evaluate effects of the surface preparation on shear bond strength (SBS) of titanium-porcelain complex. However, a completed picture has not been obtained yet. Therefore, such studies appear frequently on recent literature. The purpose of this study is to determine a simple method providing strong SBS and using fewer parameters. Materials and Methods: Sixty titanium samples were equally divided into five groups. Group 1: Control (C). Group 2: Airborne-particle abrasion with 250 μ Al2O3 (250 μ AbPA). Group 3: Etching with 10% HCl (10% HCl). Group 4: Etching with Nd:YAG Laser at 6W (Nd6). Group 5: Etching with Nd:YAG laser at 7 W (Nd7). Results: Mean SBS value of C (10.69 MPa) was close to that of 250 μ AbPA (10.57 MPa). The mean value of 10% HCl (19.37 MPa) was nearly twice higher than C, whereas those of laser groups (8.89 MPa and 8.77 MPa) were smaller than C. There was no overlap between SBS values of samples etched with 10% HCl and those of other samples. Multiple comparisons indicated a significant difference between acid group and others (p=0.00). Laser groups were different from control, too. The failure mode of % HCl group was 67% adhesive and 33% mix, while those of other groups were cohesive or mix. Conclusion: Titanium surfaces etched with 10% HCl provides significantly strong SBS values. This method requires only the use of aqueous solution of 10% HCl, and boiling process for 30 minutes. Such a simplicity suggests that etching with 10% HCl provides a very simple surface preparation method which involves in use of fewer parameters.
Authors and Affiliations
Berivan Dündar Yılmaz, Ayşe Meşe, Eylem Kaya
Keywords
Related Articles
- EP ID EP50522
- DOI 10.4274/meandros.galenos.2018.70783
- Views 260
- Downloads 0
Inherited Rare Factor Deficiencies: Single-centre Experience
Objective: Bleeding is one of the most important problems in humans. Absence, deficiency or dysfunctions of protein factors in the coagulation system can cause prolonged bleeding, morbidity or mortality. Although factor...
Effect of an MDP-containing Primer on the Bond Strength Between Ten Different Resin Cements and Air-abraded Monolithic Zirconia
Objective: The aim of the present study was to evaluate the shear bond strength (SBS) of different self-adhesive luting systems to airborne-particle-abraded monolithic zirconia ceramic, with or without the application of...
Effect of Grape Seed Extract on Bone Formation in The Expanded Interpremaxillary Suture
Objective: Widening the inter-maxillary suture is a preferred procedure in orthodontics. However, relapse can occur in some patients after maxillary expansion therapy. This study aimed to increase bone formation in the i...
The Monocyte/HDL Cholesterol Ratio in Obstructive Sleep Apnea Syndrome
Objective: Obstructive Sleep Apnea syndrome (OSAS) is the most common condition among sleep-related respiratory disorders. The etiology is not clear. However, systemic and local inflammation in the respiratory tract of t...
Anaphylaxis After the First Dose of Lansoprazole: A Case Report
Drug-induced anaphylaxis is a life-threatening condition that is rapid in onset and defined as a serious allergic or hypersensitivity reaction. Proton pump inhibitors are widely used for the treatment of acid-related dis...