THE EFFECT OF UNEVEN LOAD DISTRIBUTION ALONG THE MESHING OF THE TEETH CONTACT STRESS
Journal Title: Tribologia - Year 2012, Vol 245, Issue 5
Abstract
The paper presents issues concerning the contact stresses occurring in the surface layer of the teeth of gears. We analysed the gears found in the actual gear used in the drive wheel loaders and crawler tractors. Engineering calculations of uneven load distribution along the contact line of the teeth are determined by the factors KHβ. Assigned numerical values to these factors, depending on the accuracy performance of gears, are used for evaluating the technology used in the process of finishing. The final phase of the calculations of contact stresses and oil film thickness in the area of inter tooth, taking into account technological factors, allow the designer to make predictions concerning the durability and reliability of the propulsion systems at the design stage.
Authors and Affiliations
Jan Zwolak
Keywords
Related Articles
- EP ID EP270416
- DOI -
- Views 62
- Downloads 0
SURFACE LAYER IN THE PROCESS OF FRICTION
Chosen questions were introduced in the article the relating problems of the border layer which deciding about the resistances of the movement and the waste of the elements of the knots of the friction and processes them...
WPŁYW SIŁ ADHEZJI I LEPKOŚCI NA ZMIANY SIŁ TARCIA W UKŁADACH BIOTRIBOLOGICZNYCH
Z klasycznej teorii hydrodynamicznego smarowania wynika, że wzrost lepkości dynamicznej czynnika smarującego powoduje wzrost ciśnienia hydrodynamicznego, a także wzrost sił tarcia i zużycia. W przypadku dużych wartości c...
THE EFFECT OF THE EXPOSURE-IN-OIL ON THE CONTACT ANGLE OF THE POLYMERS FORMING SLIDING LAYERS IN HYDRODYNAMIC BEARINGS
Polymers used as the sliding layers of hydrodynamic thrust bearings are typically thermoplastics characterized by relatively high values of contact angles when compared with metals. Metals, including Babbitt, or other be...
Ocena własności tribologicznych nowych materiałów narzędziowych na osnowie niklu
W niniejszej pracy przedstawiono nowe materiały na osnowie niklu umacniane związkami faz międzymetalicznych o dużej zawartości węgla. Skład chemiczny nowych materiałów zaprojektowano tak, aby umocnienie osnowy uzyskać w...
FIELD TESTS OF RESISTANCE TO ABRASIVE WEAR OF PLOUGHSHARES MADE OF BORON STEEL
The results of the investigation of durability and ploughshare wear made from three grades of boron steel, Hardox 500, B27 and used by Lemken Company, are presented. During the research, ploughing on sandy soils was done...