The entropy analysis of radio control process
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2015, Vol 0, Issue 63
Abstract
Introduction. Macroscopic analysis makes it possible to consider the radio control process as a whole and go from casual to regular for studies of complex systems and processes. The transition to a qualitatively new level of analysis involves the dynamic models use. In this case it is possible to set the required control time, laws to reduce the entropy of the control object, the relationship between the main parameters of the process control. Problem statement. Entropy is the objective characteristic of control precision. The collection of previously collected data on the properties of the control object, disturbances and other factors form the original information. Working information is extracted in the control process. The required amount of information to reduce the control object entropy it enables to consider the process of radio control in the dynamics. The radio control dynamic model (the dynamic equation), which reveals the laws of change of the control object entropy in conditions of the control information absence and the control information availability necessary to make. It should take into consideration that the control object entropy value and the control information amount reaches a certain limit value. The model should give the opportunity to take into account the basic radio characteristics of the control object channel. Theoretical results. A dynamic model which takes into account the relationship between the rate of change of control object entropy and the amount of information that goes on the control channel was proposed. The constant rate of object entropy increase in the control absence and the constant rate of object entropy decrease in the control organization were considered. Restrictions on the potentially possible entropy values and the information amount were included. The steady state situation was analyzed. The time during which the control process can be accomplished was established. The requirement to the relation between the entropy potential value and the quantity of information was determined. The relation between the relative error of the radio control, the control object entropy value and the starting information was established. Conclusion. The results make it possible to determine the pattern of the control object entropy change, both in terms of receipt control information, and if it is the reduction in a contingency situation. On the basis of the entropy analysis procedures set a limit on the relative radio control errors, required time and the maximum value of the control object entropy. Hourly and the entropy limit for the radio control process take account the radio control channel characteristics, channel bandwidth, signal power, noise power, and the relative error of control.
Authors and Affiliations
V. Bychkovskyi, Yu. Reutskaya
Keywords
Related Articles
- EP ID EP308774
- DOI 10.20535/RADAP.2015.63.13-20
- Views 62
- Downloads 0
Driver's condition control devices
The article describes the various types of biotechnical systems of transport security, that often called by general title "Antison. Their main disadvantage is the uncertainty of detecting drowsiness phase of driver’s sta...
Taking into account the uncoordinated load when researching the structure of electromagnetic field in the microstrip using the method of ferromagnetic resonance (FMR)
The results of analysis of the causes of sizable discrepancy of data for longitudinal constituent H z obtained experimentally and numerically with the help of Microwave Studio program are given. The author also examined...
The metod of geometrical simulation of power nonharmonic determined processes and its application in radiotechnic
The example three-dimensional mathematical simulation of determined periodic power processes in radiotechnic circuits (devices) with various parameter and with nonharmonic signals is discussioned in this article. The new...
Criteria of impedance inhomogeneities approaching by delta-inhomogeneities
Introduction. Impedance δ-inhomogeneities are used for modeling of micro- and nanostructures. In this paper the criteria of impedance inhomogeneities approaching by δ-inhomogeneities are established. Input impedance of δ...
The radar signal simulation based on the analysis of Pulse-Doppler radar for digital signal processing implementation in the Matlab environment
Introduction. The complexity of modern radar (RLS) due to their versatility and the need to adapt to the interference situation is constantly changed. The models to test the basic ideas to be implemented in the radar are...