The influence of amperage of electric arc on microhardness in the area single and overlapping remeltings of HS 6-5-2 steel
Journal Title: Archiwum Odlewnictwa - Year 2011, Vol 11, Issue 3
Abstract
The present thesis depicts the microhardness of HV0,065 surface layer of high speed steel HS6-5-2 remelted with the electric arc. There were different surface layer variants of remelting used – the amperage was changed from 50 to 120A with the stable scanning speed of 300mm/min. There was also the influence of overlapping of the remeltings on the microhardness result. The highest average microhardness of the surface layer of high speed steel HS6-5-2 amounting 1100 HV0,065 was achieved by using the amperage of electric arc of 50 A. The overlapping of remeltings is connected with the possibility of occurence of the microhardness decrease in the area of overlapping of the heat influence zone of second remelting (another remelting) on the first remelting (the previous one).
Authors and Affiliations
A. Dziedzic
Keywords
Related Articles
- EP ID EP72289
- DOI -
- Views 101
- Downloads 0
Effect of ring notch radius on the decohesion mode in AlSi alloys
The article discusses the effect of the, determined by tensile test, non-linear characteristics of AlSi alloys on the value of the shape factor k for the three different sizes of the radius of the ring notch made on roun...
Compression effect and the structure of liquid eutectic
ExperimentallyT Tinvestigated theT TtemperatureT Tdependence ofT Tthe densityT and Tthermoelectric power ofT Tthe eutecticT TmeltT. TBased on theT TresultsT TandT Tstructural modeling,T Tto explain the effectT Tof compre...
Modeling of the number of stubble stuck elements after abrasive jet machining-processing
Sticking of abrasive grains into the surface is the effect of abrasive jet machining processing. For prosthetic works burnt the clay, it may deteriorate the quality of metal-clay connection. Parameters of sandblasting ha...
The effect of casting porosities on cavitational erosion of intermetallic alloy FeAl36
The machinery and equipment elements operating in a turbulent fluid flow, are exposed to destruction as a result of the impact of the cavitation, corrosion and abrasion processes, among which are hardest to minimize the...
Simulation of the ingot extraction in the continuous casting process
Cast ingot pulling speed is significantly affecting the nature of the resulting structure and the quality of the outer surface of the ingot. By introducing a variable algorithm for extraction of the ingot we may to some...