The influence of coupled horizontal–vertical ground excitations on the collapse margins of modern RC-MRFs
Journal Title: International journal of advanced structural engineering - Year 2016, Vol 8, Issue 2
Abstract
With the increasing interest in vertical ground motions, the focus of this study is to investigate the effect of concurrent horizontal–vertical excitations on the seismic response and collapse fragilities of RC buildings designed according to modern seismic codes and located near active faults. It must be stressed that only mid- to high-rise buildings are of significant concern in the context of this research. The considered structures are categorized as intermediate and special RC-MRFs and have been remodeled using distributed and lumped plasticity computational approaches in nonlinear simulation platforms, so that the utilized NL models can simulate all possible modes of deterioration. For better comparison, not only was the combined vertical and horizontal motion applied, but also a single horizontal component was considered for direct evaluation of the effect of the vertical ground motions (VGMs). At the member level, axial force variation and shear failure as the most critical brittle failure mechanisms were studied, while on the global level, adjusted collapse margin ratios (ACMRs) and mean annual frequency of collapse (kCollapse) using a new vector-valued intensity measure were investigated. Findings from the study indicate that VGMs have significant effects on both local and global structural performance and cannot be neglected.
Authors and Affiliations
Ehsan Noroozinejad Farsangi, Abbas Ali Tasnimi
Evaluation of seismic design spectrum based on UHS implementing fourth-generation seismic hazard maps of Canada
Two recent developments have come into the forefront with reference to updating the seismic design provisions for codes: (1) publication of new seismic hazard maps for Canada by the Geological Survey of Canada, and (2) e...
Investigation of the nonlinear seismic behavior of knee braced frames using the incremental dynamic analysis method
In knee braced frames, the braces are attached to the knee element rather than the intersection of beams and columns. This bracing system is widely used and preferred over the other commonly used systems for reasons such...
Seismic response of a full-scale wind turbine tower using experimental and numerical modal analysis
Wind turbine technology has developed tremendously over the past years. In Egypt, the Zafarana wind farm is currently generating at a capacity of 517 MW, making it one of the largest onshore wind farms in the world. It i...
Seismic response of an elevated aqueduct considering hydrodynamic and soil-structure interactions
In conventional design of an elevated aqueduct, apart from considering the weight of water inside the channels, hydrodynamic forces are generally neglected. In a few special cases involving high seismic zones, hydrodynam...
The influence of coupled horizontal–vertical ground excitations on the collapse margins of modern RC-MRFs
With the increasing interest in vertical ground motions, the focus of this study is to investigate the effect of concurrent horizontal–vertical excitations on the seismic response and collapse fragilities of RC buildings...