THE INFLUENCE OF THE TYPE OF GREASE ON THE SYNERGY OF ITS COMPOSITION WITH PTFE POWDER AND COPPER POWDER
Journal Title: Tribologia - Year 2016, Vol 265, Issue 1
Abstract
Studies of the influence of the type of grease on the synergistic effect of its compositions with PTFE powder and of copper during the lubrication of steel sliding pairs working in mixed friction area of were presented. Two greases, car grease 1S with a lithium thickener and grease STP with calcium thickener, were adopted for analysis. As fillers in the two lubricants, powders of two solid lubricants were PTFE and copper were used. Three lubricating compositions were tested for each of the adopted greases. Two compositions contained one filler of 5% by weight, and the third composition contained the two fillers in the same proportion (5% each). The lubricating properties of the adopted compositions were evaluated based on an experiment conducted with the use of a four–ball extreme pressure tester according to the standard PN-76/ C04147. The effectiveness of the analysed lubricants was evaluated according to four criterion values (wear of the balls d, fusion point Fz, limit wear load Goz, and wear index Ih). The results were statistically handled at the confidence level of 95% using Student’s t-test. The developed test results are shown graphically. Appropriate conclusions were drawn.<br/><br/>
Authors and Affiliations
Stanisław KRAWIEC, Michał KRAWIEC, Tadeusz LEŚNIEWSKI
Keywords
Related Articles
- EP ID EP248225
- DOI 10.5604/01.3001.0010.7579
- Views 49
- Downloads 0
DESCRIPTION OF DAMAGES OF THE DLC LAYER ON THE Si SUBSTRATE WITH REGISTRATION OF AE SIGNAL
This paper presents the results of the measurements of microindentation using Vickers’ indenter. The research was carried out with the following system: the DLC (Diamond Like Carbon) layer deposited on silicon substrate....
ANALIZA WŁAŚCIWOŚCI TRIBOLOGICZNYCH NAPOIN Z ZAWARTOŚCIĄ NIOBU W GLEBOWEJ MASIE ŚCIERNEJ
W pracy przedstawiono badania intensywności zużycia warstw napawanych w zróżnicowanych warunkach glebowych. Badaniu poddano próbki wykonane ze stali 38GSA, na powierzchnię której nałożono napoiny. Określono właściwości t...
MODYFIKACJA WARSTWY WIERZCHNIEJ SPIEKANYCH STALI NIERDZEWNYCH POPRZEZ STOPOWANIE METODĄ GTAW
Zapotrzebowanie na materiały otrzymywane przy użyciu metalurgii proszków stale rośnie, szczególnie na spiekane stale duplex, które charakteryzują się dwufazową strukturą składającą się z ferrytu i austenitu. Głównym cele...
SELECTION PROCEDURE AND PERFORMANCE OF THE TECHNOLOGICAL FEATURES OF SERVICE GENERATED LAYER
The paper presents the results of research and analysis on the relationship between selected parameters of different types of machining and the machined surface conditions. Selected parameters and treatment conditions we...
TRIBOLOGICAL PROPERTIES OF MEDIUM-CARBON STEEL AFTER NITRIDING COMBINED WITH SUBSEQUENT OXIDATION AND IMPREGNATION
The paper presents the results of examinations of tribological and corrosion properties of the layers produced on a C45 medium-carbon steel surface in the gas nitriding process combined with subsequent treatment – oxidat...