The modification process of AlSi21CuNi silumin and its effect on change of mechanical properties of the alloy
Journal Title: Archiwum Odlewnictwa - Year 2011, Vol 11, Issue 2
Abstract
Due to difficulties present during machining operations and with segregation of crystals of primary silicon, hypereutectic silumins can be used after modification only. It is why elaboration of effective modification methods is necessary for complete utilization of such alloys for machinery parts made from castings. In the paper are presented test results concerning an effect of modification with phosphor copper and strontium of AlSi21CuNi silumin on change of its mechanical properties (RBmB, AB5B) and its structure. Investigated alloy was melted in electric resistance furnace. All smelting processes were performed in temperature of 800 – 820P o PC. Obtained results concern light microscopy and strength tests of the investigated alloy. Performed tests have shown that application of phosphorus in form of CuP10 and AlSr10 master alloy as an inoculant gives positive results in form of refinement of primary crystals of silicon. Modification with phosphorus has enabled obtainment of clearly visible growth of tensile strength, Rm
Authors and Affiliations
J. Pezda
Keywords
Related Articles
- EP ID EP72441
- DOI -
- Views 92
- Downloads 0
Application of time-series analysis for prediction of molding sand properties in production cycle
Time-series analysis is characterized, as a data mining tool which facilitates understanding nature of manufacturing processes and permits prediction of future values of the process parameters or production results on th...
Influence of the microstructure and loads on tribological properties of G155CrNiMo4-3-3 cast steel
Materials for mill rolls, fulfilling high requirements due to difficult exploitation conditions, are cast steels of adamite grade. Those are cast steels of pearlitic matrix with uniformly distributed cementite precipitat...
The influence of microstructure on the mechanical properties of metallurgical rolls made of G200CrMoNi4-3-3 cast steel
The subject of the study is the high-carbon tool cast steel G200CrMoNi4-3-3 used for metallurgical rolls, especially in section rolling mills. The test material was derived from a roll damaged in production; therefore, t...
Influence of the technology of melting and inoculation preliminary alloy AlBe5 on change of concentration of Al and microstructure of the bronze CuAl10Ni5Fe4
Examining was the aim of the work: influence of the permanent temperature 1300°C ± 15°C and changing time of isothermal holding in the range 0÷50 minutes on the melting loss of aluminum in the bronze CuAl10Ni5Fe4; the qu...
Identification of temperature changes dynamics in selected castings as a contribution to performance life improvement
Parameters describing boundary conditions and dynamics of temperature changes during casting cooling in foundry moulds and the successive performance, especially as regards the massive cast elements, were discussed. Cons...