The Simulation and Analysis on Correct Operation of Tire Blowout
Journal Title: International Journal of Engineering Innovations and Research - Year 2018, Vol 7, Issue 2
Abstract
For the driving condition of vehicls’ tire blowout at high speed, it is theoretically studied. Analyzing the kinematic response of the tire blowout vehicle, and exploring the correct operation mode after tire blowout, is helpful to ensure the safety of vehicles and personnel. Based on the Dugoff tire model, a tire blowout model is established. And a 7DOF vehicle model is built in the SIMULINK. Assuming that the driver holds the steering wheel after tire blowout. Simulating the vehicle movement state after the tire blowout, the driver adopts two braking modes: continuous braking and intermittent repeated braking, then comparison and analysis the two modes. The simulation results show that the intermittent repeated braking can maintain the stability of the vehicle better under the precondition that the driver holds the steering after the left front tire blowout in a straight line.
Authors and Affiliations
Xiumin Hou, et al.
Keywords
Related Articles
- EP ID EP496558
- DOI -
- Views 106
- Downloads 0
Designing of Efficient High Voltage Three Phase Bipolar SPWM Inverter and Analysis
The SPWM inverters are widely used for energy conversion in renewable sources viz. solar power, Wind and bio¬¬ plants. The paper has evaluated the FFT performance of three different inverting architectures triggered usin...
On the Reliability-Based Design Optimization (RBDO) of A Speed Reducer
This paper proposes a modified probabilistic procedure for deriving an ultimate strength and strain design model for a speed reducer. Reliability-Based Design Optimization (RBDO) techniques have been used. A prominent de...
Empty Fruit Bunch Spreader Machine: Machine Concept
Empty Fruit Bunch Spreader machine (EFBM), is an attempt to transform manuring EFB concept in plantation. EFBM main objective is to ‘manure’ the whole EFB at frond path with distribute evenly as per layer and width same...
Improved Direct Power Control for Brushless Doubly-Fed Wind Power Generator Under Unbalanced Grid Voltage Conditions
Thepaper presents the complete modeling and control strategy of variable speed wind turbine system (WTS) driven brushless doubly fed induction generators (BDFIG). A back-to-back converter is employed for the power conver...
Electrodeposited CdTe Thin Film Solar Cells: Chloride Treatment and Improved Efficiency
The First Solar Company has recently reported the manufacturing cost of less than US$1 per Watt for their CdTe solar panels, achieving a major milestone in the quest for grid-parity [ ]. Improving cell efficiency and red...