The Technological Factors and Operating Conditions Influence on the Molybdenum Disulfide Coatings Tribological Properties
Journal Title: Journal of Materials and Engineering - Year 2023, Vol 1, Issue 4
Abstract
Molybdenum disulfide is a widely used solid lubricant operates successfully under extreme conditions such as vacuum, high or low temperatures, high loads etc. Magnetron sputtering is one of the most common method of application MoS2 coatings. It allows one to apply thin antifrictional films with high rate of purity on different substrates. The surface before application is usually prepared by abrasive processing. The aim of the work is to evaluate the magnetron deposition modes, substrate surface preparation, substrate roughness on the molybdenum disulfide coatings tribological properties. For the purpose mentioned a linearly reciprocating Ball-on-Flat (ASTM G133) Sliding Wear tests in vacuum (pressure less than 10-4 mbar) and high temperature (250 ¬¬¬0C) were conducted. The two different materials as a coating substrate was used (stainless steel and brass). The substrate surface was sandblasted. The coating surfaces structure after wear and chemical composition have been studied. The friction coefficient in vacuum at 250 °C was about 0.02–0.05. The least value was observed for the AISI 316L steel substrate treated by sandpaper and Ra 0.10 µm roughness coatings. The negative bias voltage (–20 V) during magnetron deposition leads to 16–42% lower coefficient of friction. Oxygen decreases the anti-friction properties.
Authors and Affiliations
Maksim Prozhega, Egor Reschikov, Egor Konstantinov
Keywords
Related Articles
- EP ID EP727422
- DOI 10.61552/JME.2023.04.003
- Views 49
- Downloads 0
Empirical Modeling Methods of Turning Process: A Review
This paper presents a review of the modeling methods which are widely used for empirical modeling of turning process. The review considered the scientific publications from renowned scientific resource bases from 2018 un...
FOOD PRODUCTS DEFILEMENT ANALYZER USING IOT
In order to make additional, quick profits, shopkeepers frequently adulterate food today. Foods are adulterated by adding things like ripening mangoes, chalk powder to turmeric, starch to curry powder, papaya seeds to bl...
The Technological Factors and Operating Conditions Influence on the Molybdenum Disulfide Coatings Tribological Properties
Molybdenum disulfide is a widely used solid lubricant operates successfully under extreme conditions such as vacuum, high or low temperatures, high loads etc. Magnetron sputtering is one of the most common method of appl...
Deterministic Model of Elastic Rough Contact Taking into Account the Mutual Influence of Asperities
The analytical solution of the elastic contact problem for the bodies with rough surfaces is presented using a deterministic description of the surface roughness. Particularly, a model of the normal contact of a periodic...
The Modelling of Surface Roughness After the Turning of Inconel 601 by Using Artificial Neural Network
This research includes longitudinal turning of Inconel 601 in a dry environment with PVD coated cutting inserts. Turning was performed for different levels of cutting speeds, feeds, depth of cuts and corner radius. After...