The Wear and the Radial/Axial Beat at the Conic Countersink Reamers and Countersink Reamers with Guide Pilot
Journal Title: RECENT - Year 2014, Vol 15, Issue 43
Abstract
This paper presents a method that helps to establish correctly the axial and radial beat for conic countersink reamers and for countersink reamers with guide pilot using as criteria the wear of the edges on the back edge. This paper is important because the establishment of the axial and radial beat recommended in the specialty literature, in normative or Romanian standards, does not depend on the wear of the cutting edges, fact that leads to a significant shortening of the cutting tool’s life.
Authors and Affiliations
Valentin DIȚU
Keywords
Related Articles
- EP ID EP127027
- DOI -
- Views 70
- Downloads 0
Research on the Efficiency of Thermally Insulated Feeders
The paper discusses the influence of thermal insulation of feeders on the solidification of cast parts. The employed method was computer simulation of alloy solidification. Several casting variants were analyzed involvin...
Space Management in Smart Room
Seeking to be sensitive to users, smart home researchers have focused on the concept of control. They attempt to allow occupants to gain control over their lives. Homeowners and occupants want more control of their lives...
Diagnosis of Geometrical Defects and Rebuilt Method of Machine-Tools Accuracy
Today companies are, more than ever, faced to steady growing competition and must produce higher quality at lower costs. However in industry machinery are used and suffer of accuracy, dysfunction, loss of performance, et...
Analyzing the Real Area of Contact Wear Using ANOVA
Austempering is a relatively new treatment in the field of ductile iron casting. This heat treatment was found to improve the ductile irons at high levels of strength, rendering ductile iron castings superior to steel fo...
Research about Roughness for Mating Members of a Cylindrical Fine Fit after Turning with Small Cutting Feeds
In this paper the turning with small cutting feeds for a shaft and bore of a fine fit has been studied experimentally. It has been measured obtained roughness Ra, Rz, Rq and has been correlated with shape of chips and th...