UHF PD Experiments on Real Power Transformer and its Frequency Characteristics Results
Journal Title: Engineering, Technology & Applied Science Research - Year 2016, Vol 6, Issue 1
Abstract
A number of methods have been used in partial discharge (PD) detection and recognition. Among these methods, ultra-high frequency (UHF) detection and recognition based on a single signal have attracted much attention. In this paper, a UHF PD detection system is built, and samples are acquired through experiments on a real power transformer. The received signal is decomposed into different frequency ranges through wavelet packet decomposition (WPD). In each frequency range, a pattern recognition neural network is built, and then the relationship between the information in that frequency range and PD type is described. By comparing the recognition accuracy of these networks, frequency range selection is optimized. In this specific case (the specific transformer, PD sources, and UHF sensors), results show that low frequency (156.25 MHz to 312.5 MHz) and high frequency ranges (1093.75 MHz to 1250 MHz) contain the most information for recognition. If a PD detection recognition system is to be designed, then the performance around these frequency ranges should be given attention.
Authors and Affiliations
H. Fan, J. Hu, H. Liu, Y. Yin, M. Danikas
FahamecV1:A Low Cost Automated Metaphase Detection System
In this study, FahamecV1 is introduced and investigated as a low cost and high accuracy solution for metaphase detection. Chromosome analysis is performed at the metaphase stage and high accuracy and automated detection...
Impact of Inadequate Experience and Skill on the Construction Sector in KwaZulu-Natal, South Africa
Civil engineering contractors encounter serious challenges in order to sustain their businesses, especially in a weak economic climate. A certain level of construction experience, expertise and training are required to...
A Research on the Synchronization of Two Novel Chaotic Systems Based on a Nonlinear Active Control Algorithm
The problem of chaos synchronization is to design a coupling between two chaotic systems (master-slave/drive-response systems configuration) such that the chaotic time evaluation becomes ideal and the output of the slave...
A Study of the Formation of Velocity Counter Lines and Secondary (Spiral) Flows in Different Cross Sections of Divergent, Convergent and Uniform Arcs
The mechanical properties of flow are very complex in channel arcs. Therefore, dynamic numerical models of fluids are considered effective tools in predicting such flow fields. In this study, the numerical model was vali...
Analysis of D2D Communication System Over κ-μ Shadowed Fading Channel
Outage performance of a device-to-device (D2D) communication system in the presence of co-channel interference (CCI) is analyzed in this paper. Channels for the D2D and CCI signals are assumed to be κ-μ shadowed faded. M...