UPGRADED SYSTEM OF AUTOMATION CONTROL OF THE WATER LEVEL WITH SIGNAL OF THE TEMPERATURE DIFFERENCE IN THE INSTALLATION OF STEAM GENERATION AT POWER UNIT IN VVER-1000 OF NPP
Journal Title: Вчені записки Таврійського національного університету імені В. І. Вернадського. Серія: Технічні науки - Year 2018, Vol 29, Issue 6
Abstract
The generation of saturated steam in power units of NPPs with VVER is carried out in steam generators (four steam generators per power unit). The most important regulated parameter in NGPs of NPPs, as well as for TPP boilers, is the water level, the accuracy of which depends on the quality of steam and reliability. Improvement of automated process control systems for drum boilers of average power and NPP power units is the most important means of increasing their efficiency and reliability, and one of the necessary conditions for improving the quality and reducing the cost of the final product, increasing its competitiveness both in the domestic and international markets, economic growth and technical prestige of Ukraine.
Authors and Affiliations
И. А. Ермаков, В. Ф. Ложечников
Keywords
Related Articles
- EP ID EP580246
- DOI -
- Views 47
- Downloads 0
THE INFRASTRUCTURE OF THE E-LEARNING PLATFORM FOR THE LEARNING PROCESS
The article shows the importance of using LMS in the traditional learning process. The standardization of LMS as well as the possibility of implementing Big Data technology to LMS is exemplified, as well as the scheme of...
DEVELOPMENT OF ARCHITECTURE AND SOFTWARE REALIZATION OF ELECTRONIC CABINETS OF THE DOCTOR-CARDIOLOGIST AND PATIENT
Requirements for the telemedicine system of analysis and visualization of cardiological signals are considered. Architecture and software-hardware realization of such system are proposed. The telemedicine system of elect...
CONSTRUCTION OF THE MODEL OF APPROXIMATION NONLINEAR DYNAMIC SYSTEM IN THE FORM VOLTERRA POLYNOMIAL
A method is proposed for constructing the Volterra approximating model of a nonlinear dynamical system in the time domain using polyimpulse test signals of different amplitudes. The method is based on the application of...
PRIMARY PROCESSING AND IDENTIFICATION OF BIOMETRIC INFORMATION FROM THE HEART RATE MONITOR
In the article was considered the primary processing of pulsograms with the using of hardware and software filtration. It is used for further identification and comparison with pulsograms characterizing the pathology by...
INVESTIGATION OF THE PROCESS OF DOUBLE-SIDED GRINDING OF TORCHES OF PUSHERS WITH DIFFERENT DIAMETERS
The three-dimensional geometric modeling of the instruments, the process of removing the abutment and shaping of the two-sided grinding of the pusher blades with different diameters of parts and circles with non-rotating...