USE OF OPTI - JET CS MD1MR DEVICE FOR BIOCIDE AEROSOLISATION IN 3T MAGNETIC RESONANCE
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 4, Issue 6
Abstract
The use of the biocide as a disinfectant for use in magnetic resonance rooms represents a technological challenge concerning the application of neutral electrolyzed oxidizing water (NEOW). Using a prototype OPTI - JET CS MD1 MR in magnetic resonance rooms were performed appropriate use of aerosolisation and precise dosing of NEOW. T hus, we refute the problem to disinfect apparatus 3T energy. Disinfectants of choice are therefore expected to possess properties such as rapid, residue - free action without any damaging effect on the sensitive electronic equipment. This paper discusses the use of the NEOW as a biocide for the disinfection of diagnostic rooms and equipment. Material and methods: Wee produced and used OPTI - JET CS MD1 MR aerosolisator whereby was performed aerosolization.The presence of microorganisms before and after the ae rosolisation was recorded with the help of cyclone air sampling. Colony formed units (CFU) was counted. Results and Discussion: The number of microorganisms in magnetic resonance 3T room was low as expected. Nevertheless, a possible CFU reduction of 87% was recorded. Conclusions: The research has shown that the use of EOW for the air and hard surface disinfection can considerably reduce the presence of microorganisms and consequently the possibility of hospital infections. It has also demonstrated that the use of OPTI - JET CS MD1MR is very good.
Authors and Affiliations
Robert Pintaric* , Joze
Keywords
Related Articles
- EP ID EP142963
- DOI -
- Views 73
- Downloads 0
MULTICLOUD STORAGE USING LINEAR PROGRAMMING
in our work we are going to use the concept of multi - cloud storage. These multi clouds will be different according to their quality of Service (QOS). That is each one will have different efficiency. the user will...
A NEW METHOD FOR REDUCING THE EFFECTS OF INCREASING INFORMATION IN DIGITAL IMAGE STEGANOGRAPHY
Nowadays, in order to transfer data, security is one of the most important parameters in the evaluation for transmission techniques. According to the development communicational devises, possibility of data theft submi...
ANALYSIS OF VARIOUS DEFECTS DURING ELECTROMECHANICAL ENGRAVING OF GRAVURE CYLINDER
Gravure printing process is chosen to meet high quality, long run jobs and end user expectations. This printing process is known for its versatility and print fidelity. Electromechanical engraving is one of the prominen...
DTLS & COAP Based Security For Internet of Things Enabled Devices
The Internet of Things (IoT) enables a wide range of application scenarios with potentially critical actuating and sensing function, e.g., in the e-health domain. For communication at the application layer, resour...
MEDICAL IMAGE DENOISE METHOD BASED ON CURVELET TRANSFORM: AN APPROACH FOR EDGE PRESERVATION
In medical images noise and artifacts are presented due to the measurement techniques and instrumentation. Because of the noise present in the medical images, physicians are unable to obtain required information from th...