VESSEL MIXERS WITH VIBRATION ACTIVATOR IN CONSTRUCTION ENGINEERING
Journal Title: Architecture and Engineering - Year 2017, Vol 2, Issue 2
Abstract
Construction mixes are classified as polydisperse heterogeneous systems, where surface phenomena occurring at the phase interface, exert a great influence on formation of such systems. As for mixing processes, adsorption and diffusion are the most important ones. Their speed depends on mobility of mineral constituents' particles, size of the active interfacial area, binder dispersion, technological peculiarities of the process and other factors. It is known that the vibration is one of the ways to increase mixing intensity. The article presents original designs of vessel mixers of forced action with vibration activators placed inside the mixing chamber. A vibration activator is installed in "dead" zones located along the geometrical axis of the mixing chamber where intensity of convective mixing is low. Methods of design of balanced eccentric vibration activators of precessing and plane-parallel type are considered. Results of production tests with regard to industrial designs of vibration mixers are presented. Considerable attention is paid to measurement of the vibration level reflecting the quality of dynamic balancing of the vibration activator. Vibrational impact on the environment and maintenance personnel amounts to ≈ 5 m/s2, corresponding to standard values for processing equipment as per GOST 22061-76.
Authors and Affiliations
Victor Kuzmichev, Vladimir Verstov
Keywords
Related Articles
- EP ID EP352988
- DOI 10.23968/2500-0055-2017-2-2-20-26
- Views 78
- Downloads 0
AN INTERACTIVE CONSTRUCTION PROJECT FOR METHOD OF STATEMENT BASED ON BIM TECHNOLOGIES FOR HIGH-SPEED MODULAR BUILDING
The concept and methodology for interactive design of Methods of Statement based on the use of technical and informational models, technological charts, and 3D models of construction facilities is suggested. The article...
Bending of Sawn Wood Products Obtained from Conventional Sawing and Parallel to Generatrix Sawing
This paper considers bending of sawn wood products obtained from logs by conventional sawing and sawing parallel to generatrix. Issues related to strength and stiffness of sawn wood products sawn parallel to generatrix h...
Analytical and Field Evaluation Methods of the Bearing Capacity of Deep Piles and Barrettes in Soft Soil at St. Petersburg
The standard procedure of the field evaluation methods of the bearing capacity of piles used in Russian Federation is described. A pilot deep pile (length L=52.8m and diameter D=1,2m) constructed under a multi-story bui...
CONTROL OVER DISTRIBUTION OF CONSTRUCTION LOADS ON FOUNDATIONS OF TOWER BUILDINGS
The article describes the tasks and traditional approach to organization of full-scale instrumental observations over vertical deformations of engineering tower structures. Issues related to interpretation and use of the...
IMPROVEMENT OF THE SYSTEM FOR ACCOUNTING OF PARAMETERS DURING CONSTRUCTION OF MOTOR ROADS
In the article, a necessity to improve the system for accounting of parameters for additional factors of technical condition of vehicles and road environment facilities allowed for during design and construction of motor...