VIBRATION DIAGNOSTIC OF A FRICTION PROCESS IN SLIDE BEARINGS
Journal Title: Tribologia - Year 2018, Vol 278, Issue 2
Abstract
An analysis of the condition of technical objects is carried out by diagnostic systems, the purpose of which is to detect irregularities in their operation and to prevent damages. In slide bearings, it applies to the diagnostic of friction and thermal phenomena of mating friction pairs. Among many methods of bearing diagnostics, special attention should be paid to vibration diagnostic methods based on measurements of relative vibration parameters or on absolute vibration (displacement, velocity, or acceleration of vibration). Methods of the vibration diagnostic of bearings rely on periodic or continuous measurements of relative vibration parameters of the bearing housing in relation to the rotor (in the case of slide bearings the measurements of the bearing sleeve in relation to the shaft neck) or absolute vibration parameters of the bearing housing (i.e. the sleeve in the case of slide bearing). The article presents a method of vibration diagnostics of friction phenomena that occur during the operation of slide bearings under various lubrication and load conditions. There are presented methods of analysis and the interpretation of measurement data obtained as a result of the conducted slide bearing tests on the laboratory stand. A method for assessing a technical condition of the slide bearing friction pairs is proposed.<br/><br/>
Authors and Affiliations
Dariusz LEPIARCZYK, Wacław GAWĘDZKI
Keywords
Related Articles
- EP ID EP402708
- DOI 10.5604/01.3001.0012.6978
- Views 44
- Downloads 0
WEAR TESTING OF DLC COATINGS WITH FRICTION COUPLE „BALL-ON-DISK”
A method for tribological testing of DLC coatings was developed. The method is based on “ball-on-disk” tests and ex–post inspection by optical microscopy for qualitative and quantitative determination of the specimen wea...
IDENTIFICATION OF TRIBOLOGICAL PARAMETERS CHARACTERIZING COOPERATION ROTARY SEAL WITH THE SURFACE OF THE SHAFT
This article presents a proposal for a description of tribological phenomena occurring during the cooperation of a rotary seal on the surface of a shaft, which has not been well recognized. The method of dimensional anal...
DETERMINATION OF THE ABRASIVE WEAR RATE FOR THE LOW FRICTION COATINGS USING BALL-CRATERING METHOD
In this paper, a micro-scale abrasive wear tests was used to calculate of the abrasive wear rate Kc for the coatings TiN, WC/C and MoS2/Ti. SiC particles, with a mean size diameter of 4 μm, were mixed with distilled wate...
ODDZIAŁYWANIA NOWOCZESNYCH DODATKÓW SMARNOŚCIOWYCH W FORMIE NANORUREK MoS2 W OLEJU Z NIEŻELAZNYMI POWIERZCHNIAMI TRĄCYMI
Nanorurki MoS2 są innowacyjnym dodatkiem do środków smarowych redukującym tarcie oraz zużycie stalowych elementów maszyn. Mechanizm ich działania w skojarzeniach elementów stalowych jest stosunkowo dobrze poznany i opisa...
AN ANALYSIS OF THE INFLUENCE OF JOURNAL’S HELICAL GROOVE ON THE WEAR AND LOAD CAPACITY OF THE SLIDING BEARING
The article presents the results of a sliding bearing with a helical groove on a journal. The studies included wear tests with contaminated lubrication oil and computer simulation of oil flow based on which the load capa...