WEAR OF Si OR B DOPED AMORPHOUS CARBON COATINGS
Journal Title: Tribologia - Year 2016, Vol 268, Issue 4
Abstract
The paper describes a complex wear research on DLC (amorphous carbon) doped with boron (B) and silicone (Si). The tests were carried out in two different sliding systems: flat–on–flat (ring contact, unidirectional sliding) and ball–on–flat (reciprocating sliding). Water and medical saline solutions were used as lubricants. A comparative analysis of the results revealed differences in the initiation and progress of wear and the endurance with regard to coating’s composition, lubricant and contact geometry. The results obtained from the tests show the influence of the additive element on the wear resistance and the high dependency of coatings’ performance in the type of contact and of the lubricant used. In all cases analysed, the use of medical saline solution resulted in accelerated wear or an increased result scatter in comparison to pure water lubrication.<br/><br/>
Authors and Affiliations
Krzysztof DRUET, Jacek ŁUBIŃSKI, Antoni NEYMAN
Keywords
Related Articles
- EP ID EP244269
- DOI 10.5604/01.3001.0010.6982
- Views 61
- Downloads 0
THE LUBRICITY AND LOW FRICTION ADDITIVES FOR TRANSMISSION OIL
The subject of this paper is the extension of the durability of multi-stage gear units working in moments or constant overloads. Gear oils in sugar conveyor systems of the DC tray extractor were tested. Lubrication param...
WPŁYW DODATKU WODY NA ZUŻYCIE ELEMENTÓW APARATURY WTRYSKOWEJ SILNIKA O ZS
W artykule przedstawiono problematykę zużywania się elementów aparatury wtryskowej silnika o zapłonie samoczynnym podczas dozowania wody. Obserwacji podlegał wtryskiwacz z silnika agregatu prądotwórczego KIPOR KDE3500E....
ANALYSIS OF THE POTENTIAL USAGE OF SELECTED MAGNETIC FLUIDS IN THRUST SLIDE BEARINGS
Magnetic fluids are substances whose rheological properties can be actively influenced by treatment with a magnetic field. Two main types of magnetic fluids can be distinguished: ferromagnetic fluids, and magnetorheologi...
THE MODIFICATION OF FRICTION CONDITIONS INTO CUTTING AREA AS A FACTOR INFLUENCING ON THE CUTTING PROCESS
In this paper, the results of research on cooling conditions and antiwear coating influence on chip shapes, friction coefficient values, and parameters of surface geometric structure when turning steel R35 are described....
THE EFFECT OF WATER LUBRICATION WITH ADDITION OF NON-IONIC AND ANIONIC SURFACTANTS ON THE WEAR OF THE FRICTION PAIR WITH A CONCENTRATED CONTACT
In order to minimize losses caused by friction, various technical solutions are applied. Most frequently, however, they are limited to proper lubrication. Two aspects of the problem have to be taken into consideration no...