WEAR TESTING OF a-Al2O3 OXIDE CERAMIC IN A DIVERSE ABRASIVE SOIL MASS
Journal Title: Tribologia - Year 2014, Vol 253, Issue 1
Abstract
This paper presents a comparative study of the intensity of α-Al2O3 oxide ceramic sand 38GSA martensitic steel wear in three types of abrasive soil masses, i.e. loose sand, sandy clay and heavy clay. The tests were carried out under laboratory conditions on a “spinning bowl” wear machine. Based on the obtained results, the intensity of ceramic material wear was many times lower than 38GSA steel wear. It was found that the granulometric composition had an important effect on the intensity of α-Al2O3 ceramics wear. The lowest α-Al2O3 oxide ceramics wear was obtained during friction in sandy clay, and it was 1.5 times lower than in heavy clay and 1.9 times lower than in loose sand. Differences in the types of tribological wear, depending on the granulometric abrasive mass composition, are described.
Authors and Affiliations
Jerzy NAPIÓRKOWSKI, Krzysztof LIGIER
Keywords
Related Articles
- EP ID EP263772
- DOI -
- Views 51
- Downloads 0
COMPARISON OF THE LUBRICANT PROPERTY OF WATER, OIL-IN-WATER EMULSION TYPE HFA-E AND OIL TOTAL AZOLLA 46 AS WORKING LIQUIDS IN HYDRAULIC SYSTEMS
The article characterises and describes the results of research (carried out on four-ball machine) of the lubricant property of distilled water, oil-in-water emulsion type HFA-E (1% oil in water) prepared on base of conc...
INFLUENCE OF FILLERS ON THE RHEOLOGICAL PROPERTIES OF THEIR COMPOSITIONS WITH LUBRICATING GREASES
The paper presents the results of studies on the influence of fillers, introduced into lubricating greases, on the rheological properties of resultant grease compositions. These fillers were graphite and PTFE powders. Th...
CAPACITIVE METHOD OF ELASTOHYDRODYNAMIC FILM THICKNESS MEASUREMENT
An analysis of a film thickness measurement method with thin layer transducer in an EHD contact was carried out. The construction of a sensor, a circuit model, the principle of measurement, a measurement scheme and calib...
Badania tribologiczne powłok ceramicznych natryskiwanych plazmowo
Części współczesnych maszyn często wymagają ochrony powierzchni roboczych przed działaniem korozyjnym, zużyciem oraz doraźnymi uszkodzeniami mechanicznymi. Do tego wykorzystuje się powłoki nanoszone na powierzchnie roboc...
EVALUATION OF THE LUBRICATION EFFICIENCY OF GREASES ACCORDING TO CRITERION OF WEAR EXPERIMENTALLY DETERMINED AT VARIABLE VALUES OF MOTION PARAMETERS
The results of tribological investigations into the lubrication efficiency of greases in steel sliding pairs working in mixed friction conditions are presented. The lubrication efficiency was evaluated according to the c...