A comparative study on physical properties of Al-doped zinc oxide thin films deposited from zinc acetate and zinc acetylacetonate by spray pyrolysis
Journal Title: Energetika - Year 2017, Vol 0, Issue 0
Abstract
Herein we present a comparative study on highly transparent, conductive aluminium-doped ZnO (AZO) thin films deposited by pneumatic spray pyrolysis (PSP) of a zinc acetate based solution and a zinc acetylacetonate based solution on soda lime glass. The structural, optical and electrical properties of the films were studied depending on aluminium content in the precursor solution and substrate temperature during deposition (Ts). The solution used to prepare AZO thin films contained 0.2 M zinc acetate or 0.2 M zinc acetylacetonate and aluminium acetylacetonate between 0–15 at.% [Al]/[Zn]. Substrate temperature was varied from 275 to 450 °C. Transmittance and reflectance spectra were recorded by UV-VIS-NIR spectroscopy. Resistivity, mobility and charge carrier density were determined by four point probe measurements in ambient conditions. According to X-ray diffraction analysis, AZO films are highly c-axis oriented until 2–3 at.% [Al]/[Zn] in the spray solution, depending on zinc precursor. Crystallite size is 25–30 nm for AZO films deposited at Ts 400 °C. All AZO films exhibited high average optical transmittance of 76–94% in the visible spectrum 400–800 nm wavelength range. Eg values ranged from 3.32 in undoped ZnO to 3.58 eV in in highly doped AZO films deposited from zinc acetylacetonate due to the formation of secondary AlOx phases. The lowest resistivities were obtained at Ts 400 °C for films deposited from zinc acetate, 3–7.5 at.% [Al]/[Zn] in solution (0.40 Ωcm) and at Ts 400 °C, 3–7.5 at.% [Al]/[Zn] in solution for films deposited from zinc acetylacetonate (0.47 Ωcm).
Authors and Affiliations
Jako Siim Eensalu, Malle Krunks, Inga Gromyko, Atanas Katerski, Arvo Mere
Keywords
Related Articles
- EP ID EP260790
- DOI 10.6001/energetika.v63i2.3519
- Views 100
- Downloads 0
Power quality issues in smart grids with photovoltaic power stations
Problems of power quality and electric energy accounting often occur in networks with large pervasion of photovoltaic (PV) elements on rooftops of household and office buildings. In smart grids, including PV arrays elect...
Luminescence of X-ray induced radiation defects in modified lithium orthosilicate pebbles with additions of titanium dioxide
Modified lithium orthosilicate (Li4SiO4) pebbles with additions of titanium dioxide (TiO2) are designed as a possible tritium breeder ceramic for the helium cooled pebble bed (HCPB) test blanket module. Additions of TiO2...
Numerical evaluation of systematic errors of a non-invasive intracranial pressure measurement
Intracranial pressure (ICP) monitoring procedure can be applied to aid in secondary brain damage prevention. A high invasiveness of commonly used ICP measuring methods poses a risk of complications, and therefore new non...
The use of cellular communication masts for wind share research
Prior to the start of any Wind Power Park construction project, it is necessary to carefully assess available wind potential in the selected area. The cost of such investigative studies is considerable – even with a rela...
A comparative study on physical properties of Al-doped zinc oxide thin films deposited from zinc acetate and zinc acetylacetonate by spray pyrolysis
Herein we present a comparative study on highly transparent, conductive aluminium-doped ZnO (AZO) thin films deposited by pneumatic spray pyrolysis (PSP) of a zinc acetate based solution and a zinc acetylacetonate based...