ANALYSIS OF CONTACT AND BENDING STRESSES IN GEARBOX SWITCHING UNDER LOAD
Journal Title: Tribologia - Year 2017, Vol 274, Issue 4
Abstract
The work analyses contact stresses that occur within the active surface of toothed gears as well as bending stresses that take place at the tooth root. Contact stresses have been designated at the beginning of the singletooth engagement area within the pitch point and in the end of single-tooth engagement area. Designation of bending stresses at the tooth root has been made by applying the interteeth force to the external point of single-tooth engagement. The calculated numerical values of contact and bending stresses were compared to fatigue contact durability σH lim and fatigue bending strength σF lim that were obtained experimentally. Calculations of contact stresses and bending stresses were done with multi-criterion optimisation, which makes it possible to select such geometrical parameters of toothed gears that allow utilizing fatigue durability σH lim and σF lim in reference to a given material and technology of manufacturing toothed gears.
Authors and Affiliations
Jan ZWOLAK, Marek MARTYNA
Keywords
Related Articles
- EP ID EP238747
- DOI 10.5604/01.3001.0010.6050
- Views 121
- Downloads 0
TRIBOLOGY OF CARBON COATINGS AT ELEVATED TEMPERATURE
The paper presents the results of the mechanical and tribological coatings of carbon a-C, a-C:H and a-C:N coatings. The hardest coatings H = 17 GPa is a non-hydrogenated a-C coating, while the softest one is a-C:H - 7 GP...
THE EFFECT OF ADDING AN EXPLOITATION SUPPLEMENT ON THE WEAR OF FRICTION PAIRS
The study presents the results of experimental research in the scope of modifying the operating conditions of friction pairs with the use of an exploitation supplement. Within the study, experimental research at AMSLER t...
THE INFLUENCE OF HOUSING ARRANGEMENT AND INTERFERENCE ON PRELOAD AND THEORETICAL LIFETIME OF A SYSTEM OF TAPER ROLLER BEARINGS OF A HIGH SPEED SHAFT OF A WIND TURBINE GEARBOX
A system of two taper roller bearings can carry loads with a high ratio of axial load to radial load. Such a system was proposed for a wind turbine gearbox following the poor durability of original bearing design with th...
POPRAWA WYTRZYMAŁOŚCI ZMĘCZENIOWEJ KRĄŻNIKÓW STALOWYCH PRZENOŚNIKÓW TAŚMOWYCH PRZY STOSOWANIU NAGNIATANIA DYNAMICZNEGO
Na zużycie tribologiczne krążników stosowanych w przenośnikach taśmowych ma wpływ bardzo wiele czynników. Trudność w określeniu dokładnej liczby czynników wynika między innymi ze złożonego i nie do końca zbadanego mechan...
Zwiększenie trwałości eksploatacyjnej węzłów tarcia przez zastosowanie powłok DLC typu a:C:H oraz a:C:H:W
W artykule przedstawiono wyniki badań struktury oraz testów triologicznych powłok DLC typu a:C:H oraz a:C:H:W. Powłoki otrzymywano techniką PACVD na elemenach ze stopu Co-Cr-Mo. Analizę struktury powierzchni i jej elemen...