Analysis of the Inconel 600 alloy destruction process in the surrounding of oxygen, nitrogen and hydrogen
Journal Title: Archiwum Odlewnictwa - Year 2010, Vol 10, Issue 3
Abstract
This paper presents results of research, which was targeted to define reasons of the short life of sieves made from a 0.8mm diameter wire of the INCONEL 600 alloy. It was noticed that when the sieves were used in the device for the nitrogen acid production there appeared a total loss of plastic properties of the wire. It was caused by the process of diffusion of oxygen, nitrogen and metal ions which was not stopped although the protective layer of the scale was produced. It resulted in the substantial decrease of the chromium contents (to ca 1.5%) and in oxidation of the grain boundary in the wire outer layer. The diffusion of nitrogen to the wire core caused in turn the precipitation of many Cr2N nitrides in the core.
Authors and Affiliations
M. Gajewski, J. Kasińska, R. Mola
Keywords
Related Articles
- EP ID EP72128
- DOI -
- Views 96
- Downloads 0
Use of the JM- SPC software to statistical control of high pressure die casting production-variable valued data type
Usefulness of the JM-SPC computer program for a statistical analysis of variable valued data proceeded from an Al-Si high-pressure die casting production processes was examined. An analysis subject were results of dimens...
Plastic properties of cold-deformed ironbased sintered materials
Cold plastic forming of sintered metal powders has limited practical application because of, among others, the deformation degree and initial porosity of preforms. Cold forming is combined with a very drastic drop of pla...
Analysis of power demand signal in laboratory rotary mixer
The paper summarises the power measurement data for the main assemblies in a prototype turbine mixers for laboratory applications. Of particular interest are power demand signals in the paddle stirrer and the rotor. Test...
An attempt of assessing the production perspectives concerning malleable iron castings
The paper presents a historical outline of production of the malleable cast iron castings on the territory of Poland during the past over a hundred years. There have been also gathered data concerning the total quantity...
Effect of modifying process on mechanical properties of EN AC-43300 silumin cast into sand moulds
Significance of alloy modification in course of casting process is the most explicitly visible on example of Al-Si alloys. Broad application of these alloys in foundry industry has become possible after invention of a me...