Plastic properties of cold-deformed ironbased sintered materials
Journal Title: Archiwum Odlewnictwa - Year 2010, Vol 10, Issue 3
Abstract
Cold plastic forming of sintered metal powders has limited practical application because of, among others, the deformation degree and initial porosity of preforms. Cold forming is combined with a very drastic drop of plastic properties observed in final products. One of the methods that enable regaining the lost plasticity is annealing of sinters after deformation at temperatures above the recrystallisation point. The results of the investigations were presented which aimed at the determination of an effect that the annealing conditions of colddeformed sintered metal powder can have on its structure and mechanical properties. Special attention was drawn to a combined effect of the deformation degree and heat treatment temperature on final plastic properties of the sinters and on their ultimate tensile strength.
Authors and Affiliations
K. Zarębski, S. Okoński, P. Putyra, A. Tabor
Keywords
Related Articles
- EP ID EP72238
- DOI -
- Views 95
- Downloads 0
Use of the JM- SPC software to statistical control of high pressure die casting production-variable valued data type
Usefulness of the JM-SPC computer program for a statistical analysis of variable valued data proceeded from an Al-Si high-pressure die casting production processes was examined. An analysis subject were results of dimens...
Influence of modification on the structure and morphology of fractures of silumin AlSi6Cu4
The results of modification of silumin AlSi6Cu4 with additions of AlTi5B1 and AlSr10 have been showed. It was found that the modification has favorable influence into structure and fracture morphology of tested alloy.
Influence of the microstructure and loads on tribological properties of G155CrNiMo4-3-3 cast steel
Materials for mill rolls, fulfilling high requirements due to difficult exploitation conditions, are cast steels of adamite grade. Those are cast steels of pearlitic matrix with uniformly distributed cementite precipitat...
A method for determination of complete mechanical characteristics of heterogeneous-structured materials
The article outlines the possibilities to evaluate by a modified low-cycle fatigue test the quality of materials characterised by different structures and the resulting mechanical properties. The method was described by...
Gas flow through a multilayer ceramic mould in lost wax foundry process
The paper deals with the issues of permeability testing of ceramic moulds used in lost wax foundry process. The main issue in the testing is to provide proper specimens of ceramic moulds (CM). The moulds have to be repea...