ANALYSIS OF THE STRUCTURE AND TRIBOLOGICAL PROPERTIES OF SINTERED STAINLESS STEELS
Journal Title: Tribologia - Year 2017, Vol 272, Issue 2
Abstract
Increasing development of civilization encourages the search for modern engineering materials. At present, very interesting and promising materials are sintered stainless steels that are considered to be the most rapidly developing group of materials, which is related to the demand for materials with good mechanical properties and high resistance to corrosive agents. Taking into account sintered austenitic–ferritic steels, it is possible to obtain a structure with different proportions of the two basic structural components. The main problem limiting the applicability of sintered stainless steels is porosity, which deteriorates not only the strength properties but also the usability as compared to their cast and materials after plastic working. Extremely valuable factors influencing tribological properties are the chemical composition, proportion of individual powders and sintering conditions. In this study, the microstructure and tribological properties of sintered stainless steels obtained by sintering in different proportions of 316L austenitic steel and 409L ferritic steel were compared. The abrasion wear resistance test for individual sintered steels was performed by pin-on-disc method.<br/><br/>
Authors and Affiliations
Barbara LISIECKA, Agata DUDEK, Katarzyna STRZELCZAK
Keywords
Related Articles
- EP ID EP240857
- DOI 10.5604/01.3001.0010.6312
- Views 75
- Downloads 0
TRIBOLOGICAL RESISTANCE INCREASE OF CAST IRON CYLINDER BRUSH SURFACE LAYER WITH THE APPLICATION OF LASER ABLATION TREATMENT
Results of preliminary laboratory and technology tests of cast iron after laser modification are presented in the paper. In order to improve macro- and micro-geometry of the upper layer of cylinder sliding surface, a las...
THE TESTING OF EXPLOITATION PROPERTIES OF ECOLOGICAL GREASES MODIFIED WITH POLYMER-SILICA ADDITIVE
In this article, the investigation results of the influence of developed additive AR (silica and polymer) on the change of rolling contact fatigue bearings lubricated with an ecological composition of grease are presente...
THE EFFECT OF MAGNETIC PARTICLE CONCENTRATION ON THE FERROFLUID LUBRICITY
The subject of the author’s research, whose results are presented in this article, are the chosen properties of ferrofluid. The author assumes that the concentration of magnetic particles in ferrofluid may significantly...
THE INFLUENCE OF THE LAYERED STRUCTURE OF POLYMER COATINGS ON THEIR EROSIVE RESISTANCE
The paper presents the results of erosive resistance investigation of three-layer epoxy coating systems with different compositions of surface layers. This layer was modified with glass microspheres or nanoparticles of a...
Mikrostruktura i skład chemiczny warstw granicznych, powstających z udziałem biokomponentów otrzymanych z odpadów porafinacyjnych oleju rzepakowego