ANALYSIS OF THE WEAR OF THE SURFACE LAYERS IN NATURAL SOIL CONDITIONS
Journal Title: Tribologia - Year 2015, Vol 262, Issue 4
Abstract
The following paper presents research on the wear intensity of the surface layers in natural soil conditions. The study was conducted with the steel type XAR 600 and 38 GSA on the cutting surface where welds of cemented tungsten carbides had been applied. The results of the measurements of hardness and the chemical composition of the tested materials as well as their structure are presented. During the study, the processes of the wear of specific materials in their friction were analysed. Based on the results obtained from the field tests, we may observe an increase of the resistance to the mass wear and geometrical wear that can be seen on the length and width of samples that have been welded with XHD 6710 electrodes that additionally contain chromium carbides.
Authors and Affiliations
Jerzy NAPIÓRKOWSKI, Magdalena LEMECHA, Piotr SZCZYGLAK
Keywords
Related Articles
- EP ID EP257260
- DOI -
- Views 49
- Downloads 0
THE FATIGUE WEAR OF ACETABULAR PROSTHESES PE-UHMW ON ITS TRIBOLOGICAL PROPERTIES
The paper describes a fatigue wear examination of medical PE-UHMW. Samples of polyethylene were exposed to sliding friction in reciprocating movement against ANSI 316L stainless steel. The subjects of investigation conce...
MIKROŁOŻYSKA NOWE PROBLEMY I WYZWANIA W TRIBOLOGII
Nieliniowe formy drgań w dynamice wirników, zwłaszcza po przekroczeniu granicy stabilności, a także ocena wpływu mało dokładnych i zmiennych losowo parametrów wejściowych ciągle stanowią przedmiot współczesnych badań w w...
RESEARCHING AND MODELING OF THE DYNAMIC VISCOSITY OF THE FERRO-OILS WITH THE DIFFERENT CONCENTRATIONS OF MAGNETIC PARTICLES IN THE ASPECT OF PRESSURE CHANGES
In this article, the results of the experimental research of determining the dynamic viscosity of the ferro-oils with different concentration of the magnetic particles in terms of pressure change are presented. The resea...
Wpływ zawartości dwusiarczku molibdenu w elektrolicie na właściwości tribologiczne anodowych powłok tlenkowych
W pracy przedstawiono ocenę przydatności modyfikowania dwusiarczkiem molibdenu anodowych powłok tlenkowych na stopach aluminium w celu poprawy właściwości tribologicznych powłok Al2O3. Powłoki tlenkowe wytwarzano metodą...
RESEARCH ON FRICTION RESISTANCE IN THE CONCENTRATED CONTACT STEEL – ON-MAGNESIUM ALLOY