Automated Switching Solar Power Grid Tie Inverter Using Embedded System
Journal Title: Bonfring International Journal of Power Systems and Integrated Circuits - Year 2019, Vol 9, Issue 1
Abstract
In this system solar power source is used to reduce the power source from the grid and this process mainly focused on switching power from one source to another during the time of low voltage from the solar power system. This system consists of embedded system, ADC, SCU, solar panel, inverter, drivers, step up transformer, switching unit, load, keypad, display, power supply, and grid in this process solar panel is used which produce DC voltage and the amount of power produced from the solar power system is monitored by the signal conditioning unit (SCU), the output of the SCU is given to the ADC. ADC is used to convert the analog signal to the digital signal. The digital signal is given to the embedded system. The embedded system is programmed to activate the driver and also display the voltage and current details through LCD. Then the DC voltage from the solar power system is converted into AC by using inverter. The inverter is controlled by the embedded system using drivers. Then the inverted voltage is boosted by using step up transformer and finally the power is supplied to the load by using switching unit. Switching unit is controlled by the embedded system by using drivers. This entire process is monitored and controlled by embedded system. In embedded system minimum and maximum limits are defined by using keypad to change the load setting. During peak sun hours between 11am-3.00pm maximum amounts of power is produced.
Authors and Affiliations
Dr. Balasubramaniam P. M, Michael Jayaraj TJ, Mounick Raj T, Venkatesh G, Vasanth Raj S
Keywords
Related Articles
- EP ID EP587665
- DOI 10.9756/BIJPSIC.9010
- Views 119
- Downloads 0
Investigation and Simulation of Phase to Ground Fault in DFIG based Wind Turbine System
With advent of wind farms in large scale and capacity continuously increasing, issues related to performance of the overall system needs to be addressed. Faults produced by wind turbine generator systems will impact not...
Three Phase Active Conditioner for Harmonics Mitigation
The Shunt Active Power Filter is a very essential tool to remove harmonic currents and to reimburse reactive power for nonlinear loads. The fundamental standard of process of a Shunt Active Power Filter is to introduce a...
Active Power Control in Wind Driven Variable Speed Squirrel-Cage Induction Generator
This paper describes active power control in a grid connected variable speed wind electric generation system (WEG) using squirrel cage induction machine. The chosen variable speed WEG system consists of a wind turbine, s...
Design and Implementation of Op-Amp Based Low-Power CMOS Bandgap Voltage Reference with Minimum Supply oF 0.8-V
A low power voltage source is generated by altering the device size in existing topology has been presented. Bandgap voltage reference is generated by combination of start-up, supply independent, operational amplifier (O...
Quadrature Sine Wave Signals Generated by Selection Topology and its Components
This paper presents how to generate high frequency quadrature sinewave signals by selection topology and its active and passive components. Also, presents how to choose the value of inductor by different ways followed by...