Automatization of Quantitative Structural Analysis of Composites
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2018, Vol 82, Issue 2
Abstract
The work suggests the method of automatized quantitative analysis of composite structure that boasts of the shorter investigation hours and the higher accuracy as compared with quantitative metallographic method. The method involved the processing of digital microphotographs of the structure using the special computer program and the following construction of two- and three-dimensional models of the interfacial zones at the boundaries of the composites. The interfacial zones structure was analyzed by means of the decomposition of the probability density distribution curve for the coefficients of light reflection from the polished section surface into the separate gauss curves and the calculation of the gauss curves parameters. The summary curve was decomposed by step-by-step elimination of the gauss curves from the overall distribution. The eliminated areas after taking the logarithm could be described by quadratic function. Therefore, on approximation of these areas by quadratic function, the parameters were found and the separate gauss curves were plotted. The ratio of the separate gauss curves square to their total square was equal to a relative content of the corresponding phase in the composites structure. The width of the interfacial zones was determined by the most oscillated area in a plot of light reflection coefficients as a function of section coordinate related to cartesian coordinates.
Authors and Affiliations
О. V. Sukhovа, Yu. V. Syrovatkо
Keywords
Related Articles
- EP ID EP420455
- DOI -
- Views 112
- Downloads 0
Diamond surface finishing of ceramic balls from boron carbide
The article experimentally investigates the influence of factor of machining conditions on diamond surface finishing of ceramic balls from boron carbide. The indicators of machining are rate of work removal parameter, ra...
Hemp biofuel for automotive transport. Ukrainian perspective
Ukraine takes a fourth place in the world in the technical hemp production and can use waste of hemp for biofuel (including biodiesel) production. This paper presents an analysis of cetane numbers and low-temperature pro...
Research of the stress condition of cast billets blade chisel
Models of a drill bit and a mold were developed. Melted steel pouring process was studied. Residual stresses distributions for different sections of a blade bit were studied. The highest residual stresses were observed i...
Ways of further improving the quality of iron ore concentrates at PJSC «Poltava GOK» in modern conditions
The possibility of improving the quality of magnetite concentrates by modernizing the main operations of magnetic flotation enrichment technology is substantiated. The possibility of using a moving layer of magnetite par...
Improvement of performance of finishing of details with a cutting tool
The possibilities of increasing the productivity of finishing blade processing due to the control of cutting modes are analyzed. Prospective approaches to increasing the feed and cutting speed on examples of an oblique c...