Comparison of models for the physiological estimation of internal mechanical power in cycling
Journal Title: Journal of Science and Cycling - Year 2013, Vol 2, Issue 1
Abstract
Physiological models for estimating internal mechanical power (IP) generally share a common basis: the sum of IP and the external mechanical power (EP) is equal to the total mechanical power, as represented by net VO2. While a biomechanical perspective of IP argues against this simple summation, physiological models serve a valuable purpose because they account for the total flow of energy through the system. Despite their common foundation, estimates of IP using various physiological models have not been consistent. Two pre-existing models that use a physiological approach, as well as variations of them and a simple body mass-cadence relationship, were applied to submaximal data from eight well-trained male cyclists. Three incremental cycling tests were performed at cadences of 50-55, 80-85 and 110-115 rev • min-1. Differences in the mean and limits of agreement were used to show that values of IP calculated using two previously described models were not similar at any of the cadences tested. It was also shown that using relevant energy equivalents for converting VO2 into metabolic power produced smaller values for IP than when using a generic energy equivalent. Differences in values for IP in the published literature, therefore, might not necessarily be caused by differences in participant characteristics, but rather differences in the accuracy of the variables that are input into the IP models.
Authors and Affiliations
Hedda P Brooks*| Queensland Academy of Sport, Australia.School of Human Movement Studies, The University of Queensland, Australia, Mark H Andrews| Queensland Academy of Sport, Australia., Adrian J Gray| Exercise & Sports Science, School of Science & Technology, University of New England, Mark A Osborne| Queensland Academy of Sport, Australia.School of Human Movement Studies, The University of Queensland, Australia
Keywords
Related Articles
- EP ID EP2816
- DOI -
- Views 429
- Downloads 27
Torso and facial/head pre-cooling and anaerobic cycling performance in a hot and humid environment
It has been demonstrated that cooling athletes before (pre-cooling) enabled a higher level of power output developed during exercise (Tyler et al., 2015, British Journal of Sports Medicine, 47, 7-13), increased thermal c...
Bicycle Shoe Insoles and Their Effect on Lateral Knee Movement, Leg Muscle Activation Patterns, and Performance in Experienced Cyclists
Introduction: Riders contact their bicycles at three points: hands, hips, and foot-shoe-cleat-pedal (FSCP) interface (Figure 1). Three techniques are used to achieve fit: experienced-based direct observation, technology-...
Multisensor monitoring cycle ergometer
Cycling ergometers provide a repeatable and controllable test setup to observe the effect that the mechanical (e.g. frame geometry), biomechanical (e.g. position on the bicycle) or biophysical (e.g. effect of rider posit...
The Elimination Race in Track Cycling: Patterns and Predictors of Performance
The track cycling Omnium is a multi-event competition that has recently been expanded to include the Elimination Race (ER), which presents a unique set of physical and tactical demands. The purpose of this research was t...
The effect of IMT on cycling time-trial performance at ~16°c (cool) and ~26°c (hot) temperatures
Objective: The purpose of this study was to investigate whether inspiratory muscle training (IMT) improved cycling time-trial (CTT) performance in both cool (~16°C) and hot (~26°C) environmental conditions in well-traine...