Comparison of selected surface topography parameters after the turning of Inconel 625 obtained by the additive techniques to the parameters of the material made by the traditional techniques
Journal Title: Archives of Mechanical Technology and Materials - Year 2018, Vol 38, Issue
Abstract
The paper presents the possibilities of additive manufacturing of the selected alloy, Inconel, for production of ready-made elements. The results of surface topography examination of the material manufactured with the use of the device 557 RPMI working in the LDT technology (LDT = Laser Deposition Technology) have been compared to those of a cold drawn material. The surface just after manufacturing in the two technologies has been compared to one after machining by means of variable machining parameters. The surface roughness parameter, Ssk is positive for all the surfaces of a sample made by the traditional technology, regardless of the feed. This means that most material is located close to the valleys. The surfaces are characterised by right-hand side asymmetry. In all the surfaces of the sample made by the additive technology, regardless of the feed value, the surface roughness parameter, Ssk, is negative, which means that most material is located close to the peaks.
Authors and Affiliations
Paweł Grobelny, Stanisław Legutko
Keywords
Related Articles
- EP ID EP536377
- DOI 10.2478/amtm-2018-0013
- Views 55
- Downloads 0
A STUDY OF ACTIVE VIBRATIONS DAMPING WITH THE APPLICATION OF ACTIVE TOOL
The article represents a short overview of solutions available on the market, which allow for vibrations damping during the machining process. The description also provides information on the essence of chatter vibration...
Laser borided composite layer produced on austenitic 316L steel
Austenitic 316L steel is well-known for its good resistance to corrosion and oxidation. Therefore, this material is often used wherever corrosive media or high temperatures are to be expected. The main drawback of this m...
Numerical and experimental analyses of non-energy absorbing lighting poles
Apart from the strength requirements, modern lighting pole designs have to meet a number of safety requirements in the event of collisions. The paper compares the experimental tests performed at the collision test track...
THE QUALITY MODEL OF THE AWJ CUTTING PROCESS FOR ALUMINUM TYPE PA4 ALLOY
The article presents the quality model of the process of high-pressure abrasive waterjet cutting of aluminum alloy, type PA4, as well as the results of research that verified the accuracy of the determined dependence. Th...
Evaluating the Reliability of Groove Turning for Piston Rings in Combustion Engines with the Use of Neural Networks
The article describes a method of evaluating the reliability of groove turning for piston rings in combustion engines. Parameters representing the roughness of a machined surface, Ra and Rz, were selected for use in eval...