Composition Design and Microstructure Analysis of Titanium Microalloyed New Die Steel
Journal Title: 河南科技大学学报（自然科学版） - Year 2019, Vol 40, Issue 5
Abstract
JMatPro software was used to simulate the H13 steel with different mass fraction Ti. According to the calculation results, the new mold steel with different Ti mass fraction was designed. The mechanical properties and microstructure of H13 steel with different Ti mass fraction after heat treatment were analyzed. The results show that it is reasonable to add Ti element mass fraction less than 0.600%. The tensile strength, hardness and plasticity of H13 steel containing trace Ti increase first and then decrease with the increasing of Ti content after quenching and tempering at room temperature. The performance achieves the best when the mass fraction of Ti is 0.127%. The maximum tensile strength and hardness at room temperature are 1 788 MPa and 51.5 HRC, respectively. Compared with H13 steel without Ti, it increases 264 MPa and 3. 7HRC respectively, and the reduction of area increases from 35.0% to 47.0%. The quenching and tempering micro structure of H13 steel with Ti mass fraction of 0%, 0.044% and 0.127% respectively is a mixture micro structure of tempered sorbite and tempered troostite. The quenching and tempering micro structure of H13 steel with Ti mass fraction of 0.325% and 0.536% is tempered sorbite.
Authors and Affiliations
Yongjian WANG, Yanmin ZHANG, Yaoli WANG, Kexing SONG, Yunfei WANG
Keywords
Related Articles
- EP ID EP594600
- DOI 10.15926/j.cnki.issn1672-6871.2019.05.001
- Views 76
- Downloads 0
Optimization of Shake Flask-ferment Conditions for Bacillus Lichenniformis B. LY02 Producing Cellulase
In order to improve the production of cellulase from Bacillus lichenniformis LY02( B. LY02) strain,the shake flask-ferment conditions of cellulase produced by B. LY02 were optimized by using single factor experiments. Th...
Bifurcation Analysis of Predator-prey Model
For the problem of predator-prey,a predator-prey model with generalized Holling IV functional response was studied. Under proper conditions,the model may have one degenerate equilibrium and one nondegenerate equilibrium....
Die Life Prediction and Process of Cold Rotary Forging for Hypoid Gears
In order to reduce production cost and increase production efficiency, the die life of the cold rotary forging was predicted and the process optimization was carried out. Stress and strain of the die in process of cold r...
Slicing Algorithm of STL Model Based on Reverse geometrical Intersection
1
Motor Fault Detection by Displacement Detection and LSSVM
Displacements between stators and rotors were the main reasons for induction motor faults.8 detection coils were pre-placed into the notch grooves of stator core tooth for displacement detection, and they were configured...